PLT SOLUTIONS PLT-12578 Emergency LED Wall Pack Fixture Instruction Manual

PLT SOLUTIONS PLT-12578 Emergency LED Wall Pack Fixture

WARNING

• Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.

• To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts,
  cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.

• Proper grounding is required to ensure safety.

• Power must be turned off at the breaker before installation or maintenance.

• This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.

• Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.

• Do not install damaged product. Inspect luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.

• These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.

WARNING

• Do not install this fixture during inclement weather.
• In the event of smoke or fire, call a licensed electrician.

CAUTION

• Do not use an electric generator to test this LED fixture.
• MIN 90° C supply conductors

Installation Instructions

Wiring from Back of Fixture:

1. Turn off power.
2. Remove the cover by taking out the screws.
3. Remove the 1/2″ end cap.
4. Peel off the yellow sticker and paste it on the oval area.
5. Attach the bottom plate on the oval plate.
6. Make wiring connection.
7. Screw on the cover and cover screw heads with rubber plugs.
8. Turn on the power.

1. Turn off the power.
2. Remove the cover by taking out the screws.
3. Remove the 1/2″ end cap.
4. Peel off the yellow sticker and pate it on the oval area.
5. Attach the bottom plate on the oval plate.
6. Make wiring connection.
7. Screw on the cover and cover screw heads with rubber plugs.
8. Turn on the power.

Wiring Diagram

Wiring for fixture equipped with 5W backup driver:

Battery

Make sure the battery is well connected.

972-535-0926 I pltsolutions.com I ver 012023

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>