SIGNATURE HARDWARE 949643 Whitnall Pendant Colgante Pendant Light User Manual
- June 10, 2024
- Signature Hardware
Table of Contents
SIGNATURE HARDWARE 949643 Whitnall Pendant Colgante Pendant Light User
Manual
BEFORE YOU BEGIN
We recommend consulting a professional if you areunfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation. Observe all local plumbing and building codes. Unpack and
inspect the product for shipping damage. If any damage is found, contact our
Customer Relations team via live chat at
www.signaturehardware.com or by emailing
support@siganturehardware.com
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for the installation
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at www.signaturehardware.com for product and warranty information, or contact us through live chat or by emailing support@signaturehardware.com.
FOR YOUR SAFETY
WARNING: Be sure the electricity to the wires you are working on is shut off, either the fuse is removed or the circuit breaker is shut off. You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.
CARE INSTRUCTIONS
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper
TOOLS AND MATERIALS:
-
Safety goggle
-
Step ladder
-
Wire strippers
-
Wire cutters
-
Phillips screwdriver
-
Flathead screwdriver
-
Electrical tape
-
Light Bulb (A19 60 watt maximum)
SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE. READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT OR INSTALLATION QUESTIONS PLEASE CALL CUSTOMER SERVICE AT 1-800-221-3379.
INSTALLATION (FIG 1)
- Slip first stem (K) along wire and thread into coupling (L) of main fixture body.
- Repeat step 1 for assembly stems (G), (H), (I), (J) and swivels (F).
INSTALLATION (FIG 2)
-
Thread the mounting screws (A) into the matching holes in the mounting bar (B).
-
Secure mounting bar (B) to the outlet box with outlet box screws (C).
-
Please note: The ribbed wire will be a neutral wire, and the smooth wire will be a lead wire. The smooth wire will also have a printed temperature warning. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.
-
Connect the white wire from the fixture to the white wire from the outlet box and the black wire from the fixture to the black wire from the outlet box. Cover the two wire connections using the two provided wire connectors. Wrap the two wire connections with electrical tape for a more secure connection. Attach the grounding wire connections with electrical tape for a more secure connection. Connect the copper ground wires from the fixture and from the outlet box to the ground screw on the mounting bar.
Note : If you have electrical questions, consult your local electrical code for approved grounding methods. -
After wires are connected, tuck them carefully inside outlet box. Raise the canopy (D) allowing for the mounting screws (A) to protrude through the holes on canopy (D), and secure with the ball nuts (E).
-
Install light bulb (Not provided). Please do not exceed the maximum wattage capacity recommended on the socket
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>