PEREL SOL50F Solar Flexible Panel User Manual
- June 10, 2024
- PEREL
Table of Contents
PEREL SOL50F Solar Flexible Panel
Product Information
The SOL50F/SOL100F is a solar panel system designed for charging batteries in various applications. It comes with a user manual that provides detailed information on installation, usage, and maintenance.
Safety Instructions
- Read and understand the manual and all safety signs before using this appliance.
- Do not use sharp metal tools or any other tools that can scratch the surface of the module.
- Never disconnect a module under load.
- This device can be used by children aged from 8 years and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the device in a safe way and understand the hazards involved.
General Guidelines
- All modifications of the device are forbidden for safety reasons.
- Only use the device for its intended purpose. Using the device in an unauthorized way will void the warranty.
- Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.
Connection
- Connect the negative pole of the panel to the negative pole of the charge controller (not included). Similarly, connect the positive pole of the panel to the positive pole of the charge controller.
- Single-Panel Connection: The solar module should be connected to a battery system via a charge controller.
- Parallel Connection: Connect your solar modules in parallel by connecting the positive to positive and the negative to negative.
- Series Connection: Connect your solar modules in series by connecting the positive of one module to the negative of the next module.
Cleaning and Maintenance
- Keep the appliance clean.
- In a marine environment, rinse often with fresh water to avoid salt build-up.
- Periodically check electrical connections and wires.
- Periodically check mounting and securing.
Technical Specifications
- Use this device with original accessories only.
- Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device.
- The information in this manual is subject to change without prior notice.
Product Usage Instructions
- Read the user manual thoroughly before bringing the device into service.
- If the device was damaged in transit, do not install or use it and contact your dealer.
- Connect the SOL50F/SOL100F solar panel system to a battery system via a charge controller. Connect the negative pole of the panel to the negative pole of the charge controller and connect the positive pole of the panel to the positive pole of the charge controller.
- You can connect your solar modules in parallel by connecting the positive to positive and the negative to negative. Alternatively, you can connect your solar modules in series by connecting the positive of one module to the negative of the next module.
- Keep the SOL50F/SOL100F solar panel system clean. In a marine environment, rinse often with fresh water to avoid salt build-up. Periodically check electrical connections and wires as well as mounting and securing.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device
after its lifecycle could harm the environment. Do not dispose of the unit (or
batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling. This device should be returned to your distributor or
to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, do
not install or use it and contact your dealer.
Safety Instructions
Read and understand this manual and all safety signs before using this
appliance.
Caution, risk of electric shock.
Photovoltaic modules generate DC current when exposed to sunlight or other
light sources. Although a single module produces only low voltage and current,
shocks and burns are still a potential hazard. The shock hazard increases as
modules are connected in series. Cover the whole front of the module with a
dense opaque material such as cardboard when installing and handling the
module. Work under dry conditions only.
Make sure you fully understand the instructions before installing the module.
Contact a qualified technician if in doubt.
This device can be used by children aged from 8 years and above, and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concerning
the use of the device in a safe way and understand the hazards involved.
Children shall not play with the device. Cleaning and user maintenance shall
not be made by children without supervision.
Never disconnect a module under load.
Install the module horizontally or vertically with the connection box at the
top. The solar module should be facing south at an angle of 0-20°. Bear in
mind that if the solar module is cast in shadow, its power output will drop
considerably. Choose a location for the module with as little shade as
possible.
Do not use sharp metal tools or any other tools that can scratch the surface
of the module.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this
manual.
All modifications of the device are forbidden for safety reasons. Damage
caused by user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered
by the warranty and the dealer will not accept responsibility for any ensuing
defects or problems.
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary,
incidental or indirect) – of any nature (financial, physical…) arising from
the possession, use or
failure of this product.
Keep this manual for future reference.
Connection
Tips
- Use suitable connection cables – preferably UV-resistant cables with section 2.5-4 mm² –depending on the length of the cables and the size of the panel. We recommend using the Velleman SOL/SPC3 cables (not included).
- Connect the negative pole of the panel to the negative pole of the charge controller (not included). Similarly, connect the positive pole of the panel to the positive pole of the charge controller.
General
- Coat the wires and terminal posts with Vaseline® to protect them from corrosion.
- Make sure the connection box is tightly closed to prevent moisture from entering.
- If the solar module is to be mounted in a coastal area, it is extra important to protect the installation from moisture to prevent saltwater corrosion.
Schemes
Single-Panel Connection
The solar module should be connected to a battery system via a charge
controller.
Parallel Connection
Connect your solar modules in parallel by connecting the positive to positive
and the negative to negative.
Series Connection
Connect your solar modules in series by connecting the positive of one module
to the negative of the next module.
Cleaning and Maintenance
This appliance does not require excessive maintenance.
Keep the appliance clean. In a marine environment, rinse often with fresh
water to avoid salt build-up.
Periodically check electrical connections and wires.
Periodically check mounting and securing.
Technical Specifications
SOL50F
- maximum power (Pmax) ………………………………………………………………………………. 50 W
- voltage at Pmax (Vmp) ……………………………………………………………………………….. 17.6 V
- current at Pmax (Imp) ……………………………………………………………………………….. 2.86 A
- open-circuit voltage (Voc) ……………………………………………………………………………. 21.1 V
- short-circuit current (Isc)…………………………………………………………………………….. 3.15 A
- temperature coefficient of Voc …………………………………………………… (0.065 ± 0.015) %/°C
- temperature coefficient of Isc ……………………………………………………… -(80 ± 10) mV %/°C
- temperature coefficient of power …………………………………………………… -(0.5 ± 0.05) %/°C
- NOCT ………………………………………………………………………………………………… 47 ± 2 °C
- operating temperature ………………………………………………………………….. -40 °C to +85 °C
- maximum system voltage …………………………………………………………………………. 600 VDC
- power tolerance ………………………………………………………………………………………… ± 5 %
- cells ………………………………………………………………………. multi-crystalline silicon solar cell
- number of cells and connections ……………………………………………………………….. 32 (4 x 8)
- module dimensions …………………………………………………………… 645 x 535 x 3 mm (0.12″)
- weight ………………………………………………………………………………………. 1.6 kg (3.56 lbs.)
SOL100F
- maximum power (Pmax) …………………………………………………………………………….. 100 W
- voltage at Pmax (Vmp) ……………………………………………………………………………….. 17.6 V
- current at Pmax (Imp) ……………………………………………………………………………….. 5.72 A
- open-circuit voltage (Voc) ……………………………………………………………………………. 21.1 V
- short-circuit current (Isc)…………………………………………………………………………….. 6.30 A
- temperature coefficient of Voc …………………………………………………… (0.065 ± 0.015) %/°C
- temperature coefficient of Isc ……………………………………………………… -(80 ± 10) mV %/°C
- temperature coefficient of power …………………………………………………… -(0.5 ± 0.05) %/°C
- NOCT ………………………………………………………………………………………………… 47 ± 2 °C
- operating temperature ………………………………………………………………….. -40 °C to +85 °C
- maximum system voltage …………………………………………………………………………. 600 VDC
- power tolerance ………………………………………………………………………………………… ± 5 %
- cells ………………………………………………………………………. multi-crystalline silicon solar cell
- number of cells and connections ……………………………………………………………….. 32 (4 x 8)
- module dimensions …………………………………………………………..1150 x 535 x 3 mm (1.12″)
- weight ………………………………………………………………………………………. 2.2 kg (7.68 lbs.)
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of damage or injury resulting from (incorrect) use of this device. For more info concerning this product and the latest version of this manual, please visit our website www.perel.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written
consent of the copyright holder.
Velleman® Service and Quality Warranty
Since its foundation in 1972, Velleman® acquired extensive experience in the
electronics world and currently distributes its products in over 85 countries.
All our products fulfil strict quality requirements and legal stipulations in
the EU. In order to ensure the quality, our products regularly go through an
extra quality check, both by an internal quality department and by specialized
external organisations. If, all precautionary measures notwithstanding,
problems should occur, please make appeal to our warranty (see guarantee
conditions). General Warranty Conditions Concerning Consumer Products
(for EU):
- All consumer products are subject to a 24-month warranty on production flaws and defective material as from the original date of purchase.
- Velleman® can decide to replace an article with an equivalent article, or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses are out of proportion. You will be delivered a replacing article or a refund at the value of 100% of the purchase price in case of a flaw occurred in the first year after the date of purchase and delivery, or a replacing article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery.
- Not covered by warranty:
- all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity…), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits;
- consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, nonrechargeable, built-in or replaceable), lamps, rubber parts, drive belts… (unlimited list);
- flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…;
- flaws caused deliberately, negligently or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions;
- damage caused by a commercial, professional or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally);
- damage resulting from an inappropriate packing and shipping of the article;
- all damage caused by modification, repair or alteration performed by a third party without written permission by Velleman®.
- Articles to be repaired must be delivered to your Velleman® dealer, solidly packed (preferably in the original packaging), and be completed with the original receipt of purchase and a clear flaw description.
- Hint: In order to save on cost and time, please reread the manual and check if the flaw is caused by obvious causes prior to presenting the article for repair. Note that returning a non-defective article can also involve handling costs.
- Repairs occurring after warranty expiration are subject to shipping costs.
- The above conditions are without prejudice to all commercial warranties. The above enumeration is subject to modification according to the article (see article’s manual).
Made in PRC
Imported for PEREL by Velleman nv
Legen Heirweg 33, 9890 Gavere, Belgium
www.perel.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>