HiB 79110000 Illuminated Mirrors User Manual
- June 4, 2024
- HiB
Table of Contents
HiB 79110000 Illuminated Mirrors User Manual
Thank you for purchasing this HiB product.
Please read through these instructions carefully and refer back to them during installation to ensure that your product is fitted safely and that it retains its high quality finish.
Please retain this leaflet for future reference.
Before installation, ensure the domestic electrical mains supply to which the
mirror is to be connected is turned off.
Before drilling, ensure that there are no hidden cables or pipes in the wall.
This product is suitable for installation in zones: 2 & Outside Zone
All installations must comply with guidelines which are based on a zonal
concept. The diagram above illustrates this concept and must be followed to
ensure the safe installation of electrical appliances in the bathroom. These
regulations apply to domestic installations only.
HiB recommends that all electrical bathroom products must be installed in
accordance with current building and wiring regulations. If in doubt please
contact an electrician.
Installation
-
Position the mirror in a suitable location (according to the zonal diagram – Fig. 1), ensuring that the domestic electrical mains supply is within reach of the cable connection point of the product. See Fig. A.
-
Carefully mark the position of the mirror using a soft pencil ensuring it is level. Remove the mirror and mark the mounting points (see Fig. A) Please ensure that all marked mounting points accurately match up with the fixing points on the mirror.
-
Using a suitable drill bit, drill holes in the marked positions to a suitable depth. If drilling through tile, use a ceramic drill bit.
-
Insert wall plugs level with the surface of the wall. If fitting to a tiled surface, wall plugs should be inserted below the tile surface to avoid cracking. NB. For plasterboard walls, specialist fixings should be purchased, available from any DIY or hardware store.
-
Screw supplied fixings into wall plugs.
-
Ensure the domestic electrical mains supply to which the mirror is being connected is turned off. Connect the domestic mains supply to the terminal box according to the wiring diagram opposite (Fig. B).
-
Hang the mirror in position.
-
Switch the domestic electrical mains supply for the mirror back on.
This product contains a light source of energy efficiency class E
Operation Instructions
To turn illumination on touch the sensor once.
To change the colour temperature, touch and hold the sensor until desired
colour is obtained. The colour temperature is then set until changed again.
Heated pad is only on when mirror is illuminated.
Care Instructions
Do not use abrasives or solvents when cleaning this product.
Wipe off all water spillages as soon as possible using a soft, damp cloth.
WEEE compliance
Must not be mixed with general household waste
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>