GRIOTS GARAGE 38953 Compact Sit-On Creeper II Instructions
- June 4, 2024
- GRIOTS GARAGE
Table of Contents
38953 Compact Sit-On Creeper
II Instructions
ITEM# 38953 | INSTRUCTIONS
Compact Sit-On Creeper II
ITEM, HARDWARE & PARTS INCLUDED
| # | UNIT | QTY | # | ITEM | UNIT | QTY | |
|---|---|---|---|---|---|---|---|
| A | Main Body Assembly w Mini-Creeper Installed | SET | 1 | 4 | M6 Washer | PCS | 8 |
| 1 | Tool Tray | PCS | 2 | 5 | M6 Nyloc Nuts | PCS | 4 |
| 2 | Bottom Frame and Wheel Assembly | SET | 2 | 6 | Center ()rawer | PCS | 1 |
| 3 | M6 x 45mm Screw | PCS | 4 |
IMPORTANT: READ ALL INSTALLATION STEPS BEFORE BEGINNING ASSEMBLY
Tools Required: 4mm Hex Driver or Allen Wrench and 10 mm socket with
driver/ratchet
Installation Steps:
- Organize all components in a clean space on a workbench or the floor. The Mini Creeper is factory pre-installed on the creeper frame. The full Mini Creeper can be removed by placing a foot on a wheel and pulling the seat top upwards. Removing the Mini Creeper is not necessary for assembly.
- Place the Compact Sit-On Creeper II main body assembly (A) upside down on your work surface.
- Take one of the Bottom Frame and Wheel Assembles (2) placing it on the main body assembly with the casters aligned outwards and the fastener holes lined up.
- Insert two M6 x 45 mm screws (3) with washers through the mounting holes from the top side of the main body assembly frame (See Fig: 1). Place two M6 nylon nuts (5) with washers (4) onto the screws protruding through the bottom of the Bottom Frame and Wheel Assembly (2). Holding the screws with a 4 mm hex driver, tighten the M6 nylon nuts (5) with a 10 mm socket and driver/ratchet until they are snug to the bottom frame. Do not over-tighten.
- Repeat steps 3-4 with the second Bottom Frame and Wheel Assembly (2) piece on the other side.
- Turn the creeper assembly over onto its wheels. Double-check that all fasteners are tightened securely.
- Take Tool Tray (1) and insert on one side of the cart bottom frame at a 45-degree angle. Push downward firmly on the end of the Tool Tray near the bottle holders until the clips lock into place on the frame. If locking the trays in place is difficult you can reach underneath the tray and push the clips inward toward the center of the creeper to allow the trays to lock in place easily (See Fig: 3). Repeat with 2nd Tool Tray on the opposite side of a creeper.
- Sit on the cart and test that all casters and frame pieces are fully secure. If not, re-tighten any loose fasteners. Now go have fun in your garage!®
Note: Over time with regular use, there is a chance that fasteners may
become loose. Check fasteners periodically to ensure everything is secure and
safe for use. The creeper body and trays can be safely cleaned with multiple
products including Interior Cleaner, Interior Detailer, Speed Shine®, etc.
CAUTION: DO NOT stand on the full creeper or Mini Creeper for any reason!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>