GRIOTS GARAGE 51490 Mini Creeper Instructions
- June 4, 2024
- GRIOTS GARAGE
Table of Contents
Mini Creeper
And Mini Creeper upgrade for
Compact Sit-On Creeper I
ITEM# 51490 | INSTRUCTIONS
51490 Mini Creeper
ITEM, HARDWARE & PARTS INCLUDED
| # | ITEM | QTY |
|---|---|---|
| 1 | Complete Mini Creeper Assembly | 1 |
IMPORTANT: READ ALL INSTALLATION STEPS BEFORE BEGINNING ASSEMBLY
Tools Required: 4mm Hex Driver or Allen Wrench Installation Steps:
- With your Compact Sit-On Creeper sitting upright on its casters, loosen the top four 4mm hex fasteners (1), two on the front of the creeper and two on the back, using a 4mm Allen wrench or hex driver. (See Fig: A)
- Lay your Compact Sit-On Creeper on its back so that the drawer front is facing up. Remove the drawer (2) and set it aside. Now, loosen and remove the remaining two 4mm hex fasteners with washers (1)(3). Place hardware together in a secure location.
- Turn your creeper over so that the drawer backside is facing up and completely remove the top two 4mm hex fasteners and washers (1) that were loosened in step 1. Place hardware together in a secure location.
- Turn your creeper back over so that the drawer opening is facing up. Lifting slightly on the corner of the seat surface close to the front panel (4), remove the front panel, and set it aside (if necessary, shake the front panel slightly to release the joint with the seat)
- Stand the creeper up onto its casters and lifting slightly on the corner closest to the side of the seat that is still attached, remove the seat (5) from the creeper (if necessary, shake the seat slightly to release the joint with the back panel).
- Remove the black round tubes from the seat and you are ready to reassemble your creeper for use with the Mini Creeper attachment.
- Place the black round tubes (6) into the round recesses at the top corners of the back panel and secure them with the 4mm hex fasteners removed earlier (1), torque the fasteners but do not overtighten.
- Lay the creeper on its back panel again. Checking that the drawer housing sleeve is lined up with its recess in the front and back panels, place the front panel (4) back onto the creeper frame. Ensure the top round recesses in the front panel fit the black round tubes and that the bottom square recesses fit the bottom frame cross bars. Secure the front panel with the four 4mm hex fasteners (1)(3) removed in step 2.
- Once all fasteners are tight, you are ready to install your new Mini Creeper. Simply center the Mini Creeper over the top of your Compact Sit-On Creeper frame, lining up the recesses in the bottom of the Mini Creeper with the 2 round bars in the creeper frame, and press down firmly until you hear the two pieces click together (See Fig: B). You are now ready to have fun in your garage with the versatility of a 2-in-1 creeper.
- To remove the Mini Creeper from your Compact Sit-On Creeper frame for use, simply place a foot on one caster and pull up on the same end of the Mini Creeper, unlocking it from the frame bars.
CAUTION: DO NOT stand on the full creeper or Mini Creeper for any reason!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>