Schneider Electric XUK0AKSAM12 Photo Electric Sensor Installation Guide
- June 10, 2024
- Schneider Electric
Table of Contents
XUB
Osiconcept photo-electric sensors
XUK0AKSAM12 Photo Electric Sensor
Key
| RD | Red | Rouge | Rot |
|---|---|---|---|
| YW | Yellow | Jaune | Gelb |
| GR | Green | Vert | Grün |
RD-Fault
YW-Output
GR-Power supply (teach status)
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
– Disconnect all power before servicing equipment. Failure to follow these
instructions will result in death or serious injury.
Electrical equipment should be installed, operated, serviced, and maintained
only by qualified personnel. No responsibility is assumed by Schneider
Electric for any consequences arising out of the use of this material.
Troubleshooting help Defects – Causes – Remedies
| Status | Diagnostic | I Causes (Actions |
|---|---|---|
| Setting | ||
| Green | (nit mode or press < 3 s | — |
| Red | Environment is incorrect | Range limit (Reflex, obstacle) |
alignment conditions + restart learning (press > 3 s)
Red| Alignment is incorrect| Off limit| Review the setting
Setting limit| Range limit| Review the setting
Operation
Red| Fine setting failed| Object is absent| Position the object or reset
(press > 9 s)
Fine setting failed| Object is too clear| Reset (press > 9 s)
Fine EFFAR setting failed| Too close to background| Reset (press > 9 s)
Fine direct REFLEX setting failed (Proxi)| Insufficient threshold level| Reset
(press > 9 s)
Red| Clogging| “Lens polluted”| Optical cleaning; preventive maintenance
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>