RUGGED RIDGE 11543.15 JK Winchplate for Mopar Stamped Steel Bumper User Guide
- June 15, 2024
- RUGGED RIDGE
Table of Contents
11543.15 JK Winchplate for Mopar Stamped Steel Bumper
Part #11543.15
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024
PHONE:770-614-6101 | FAX:
770-614-6069 | info@omix-
ada.com
JK Winchplate for Mopar Stamped Steel Bumper
Winch Plate Components
- Bottom Plate ……………………………….(1)
- Top Plate …………………………………. (1)
- M10 Hex Bolt ……………………………….(6)
- M10 Flat Washer …………………………….(6)
- M10 Nutplate …………………………………. (2)
- M6 Hex Bolt …………………………………. (2)
- M6 Flat Washer ……………………………. (2)
- M6 Lock Nut …………………………………. (2)
JK Winchplate for Mopar Stamped Steel Bumper
-
Remove factory bumper and skidplate.
-
Disconnect turn signal from behind grille. Rotate bulb assembly down and pull out of light housing.
-
Raise hood and remove (6) plastic fasteners on top of grille. First pull up on center pin, then pull up on entire plastic retainer assembly (these will be reused in later steps).
-
Pull bottom of grille away from vehicle to disengage metal clips on bottom rear of grille. Remove factory grille from vehicle.
-
Remove factory plastic closeout panel by releasing the plastic fasteners that attach to each frame rail.
-
Unbolt and remove factory vacuum pump. Retain factory bolts.
-
Using cutoff wheel, remove both tabs from mounting bracket. Remove as much material as possible.
-
Coat exposed metal with rust-inhibiting lack paint.
-
Disconnect hose retainer clips from vacuum pump and remove zip ties holding air lines.
-
Attach vacuum pump to Winch Plate using M6 Hex Bolts, Flat Washers, and Lock Nuts supplied with Winch Plate.
-
Install Winch Plate by first placing Bottom Plate between frame horns.
-
Position Top Plate onto frame horns with rear flange located forward of Bottom Plate rear flange.
-
Attach Top and Bottom Plate at rear flange with M10 Hex Bolts and Flat Washers supplied with Winch Plate.
-
Attach Winch Plate to top of each frame horn using M10 Hex Bolt and M10 Nut Plate supplied with Winch Plate.
-
Reconnect vacuum pump and reinstall grille.
-
Position Bumper Assembly over frame rails, aligning Tow Hooks with mounting holes on frame horns. Secure with OE Nuts.
-
Install winch and fairlead.
-
Install Grille (installation is reverse of removal).
OMIX-ADA® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
EMAIL: techsupport@omix-ada.com
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Copyright © 2015 Omix-Ada® , Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>