BLITZSHARK SRK-CH58L 12V Kids Ride on Car Compatible for Chevrolet Tahoe Battery Powered Instructions

BLITZSHARK SRK-CH58L 12V Kids Ride on Car Compatible for Chevrolet Tahoe

Battery Powered

• Suitable for 3-8 years •
• Maximum user weight: 55lbs/25 kg •
• Adult assembly required •

NOTE
Please install this ride-on car according to the instructions and the installation video on the detail page of your purchased product.

Charge for 12 hrs before initial use. After the initial charge, follow the normal recommended charging time.

Tip: The original box is needed for returns & exchanges. We strongly recommend you keep it in case of contingencies.

SAFETY

Instruction sheet and packaging must be retained since it contains important information.

NOTE
For best performance, only use this vehicle on flat and hard surfaces.

• AGE RANGE
  

  • 3 to 8 years old

• WEIGHT CAPACITY

  • 55lbs (25KG) is the maximum weight for 1 rider (combined)

WARNING
The following safety hazards may result in serious injury or death:

• This product contains small parts. Keep children away during assembly. Make sure to remove all packaging material and parts from underneath the vehicle body.
• Never open the battery. Batteries contain lead and lead compounds (acids).
• Limbs, hair, and clothing can get caught in moving parts. Always wear shoes, keep limbs away from moving parts, and do not wear loose clothing while operating this vehicle.
• This vehicle does not have brakes or braking capability. Do not leave a child unattended during operation. Do not use this in a location that may require braking capability. As this could result in loss of control, which may cause serious injury or death.
• Use of this vehicle near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night, or in the dark could result in an unexpected accident.
• Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand, or gravel may result in an unexpected accident such as tipping over, and could damage the electrical system or battery.
• Do not operate this vehicle in an unsafe manner. Examples include but are not limited to:
  • Pulling the vehicle with another vehicle or similar device
  • Allowing more than one child to ride
  • Pushing the user
  • Traveling at an unsafe speed
• The battery charger used with the electric toy shall be regularly examined for damage to the supply cord, plug, enclosure or other parts, and in the event of damage, it shall not be used until the damage has been repaired.

BATTERY WARNINGS

WARNING
The following safety hazards may result in serious injury or death:

• Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion. Only use the supplied battery and charger.
• Use of the rechargeable battery and charger for any other product may result in overheating, fire or explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not charge the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact between the terminals. Picking up the battery by the wires or charger can cause damage to the battery and may result in a fire. Always pick up the battery by its case or handles.
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury. If contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the eyes, flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not induce vomiting.
• Battery posts, terminals, and related accessories contain lead and lead compounds(acid).
• Tampering or modifying the electric circuit system may cause a shock, fire or explosion and permanently damage the system. Exposed wiring and circuitry in the charger may cause electric shock. Always keep the charger housing closed.

WARNING

• Non-rechargeable batteries are not to be recharged.
• Make sure the charger connector is matching with the battery connector.
• Make sure the brand, voltage and frequency of the chargers are by the wall outlet.
• Batteries are to be inserted with the correct polarity.
• The supply terminals are not to be short-circuited.

Charge the battery: The first charge will take about 12 hours.

• Charge the battery directly from the socket near the seat.
• Take out the battery. Charge the battery independently.

WARNING

• Plug the battery connector into the charger port.
• Plug the charger into a standard wall outlet.
• Only use the 12 volt charger to charge your 12 volt battery.
• Note: If Power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 12 hours. Never charge the battery longer than 24 hours.
• Recharge the battery for at least 8-10 hours after each use of your vehicle.
• Do not charge the battery longer than 24 hours.
• Do not charge or store the battery upside down. Charging produces may explosive gases. Charge away from flames, sparks and lit cigarettes. Charge in a well-ventilated area.
• Once the battery is charged, disconnect the battery connector from the charger connector. Unplug the charger from the wall outlet. The battery is now ready to be installed to your vehicle.

USER WARNINGS

The following safety hazards may result in serious injury or death:

• Never leave a child unattended.
• Always sit in the seat when using this vehicle.
• Keep your hands, hair, and clothes away from moving part.
• Always wear shoes when operating this vehicle.
• Maximum of one child are allowed in the vehicle at a time.
• Children under 3 years of age cannot use the vehicle.
• Only drive on level ground.
• Do not go near swimming pools or other bodies of water, drop-offs or up and down steep inclines.
• Do not drive the vehicle into loose dirt, mud, sand, fine gravel or on wet surfaces.
• Do not drive the vehicle on streets or near cars.

TOOLS REQUIRED

• Please identify all parts before assembly and save all packaging material until assembly is completed to ensure that no parts are discarded
• Metal parts have been coated with lubricant for protection during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant.

PRODUCT ASSEMBLY

Part 1
Insert the rear support and fasten it with 9 screws.

Part 2
Rear wheels: Assemble all the parts in sequence as picture and use the socket tool to fasten. Repeat the same procedures for the other side.

Part 3
Front wheels: Assemble all the parts in sequence as picture and use the socket tool to fasten. Repeat the same procedures for the other side.

Part 4
Plug connectors, place the steering wheel into the turning shaft.

Part 5

1. Battery assembly: Plug connectors as the picture.
2. Wire Connection: Connect the two red plugs as shown.

Part 6
“Snap” the tabs on the seat into the slots of the vehicle.

Part 7
Secure the seat by the seat lock.

Part 8
“Snap” the tabs on the windshield into the slots in the front top side of the vehicle.

Part 9
“Snap” the tabs on the side mirror into the slots. Repeat the same procedures for the other side.

OPERATING YOUR VEHICLE

Reverse
Push the shifter in a downward position and press the accelerator slowly.

Power switch
Switch button ON and OFF.

Forward
Push the shifter in an upward position and press the accelerator slowly.

Low speed
The vehicle has been pre-set to operate at low speed (1.5 mph, (3.0 kmh) maximum). Once your child has mastered safe driving skills and understood the Safe Driving Rules.

High speed
Vehicle to be driven at a higher speed (2 mph, (3.5kmh) maximum). Make sure your child can safely steer and operate the vehicle and know the rules for safe driving.

Stop
The vehicle will automatically stop after the accelerator is released.

Sound effect
Press the buttons on the sides of the steering wheel. Each button will make a different sound effect.

Safety device
AUTO POWER OFF. If the motor is overloaded for any reason, including improper usage, an electrical circuit breaker
will automatically cut off the power, then resume after the parts have cooled!

Maintenance

• Clean with a dry, soft cloth only. Do not wash with water or corrosive agents.
• Store the vehicle in a dry area when not in use, since moisture could cause the metal components and electrical parts to corrode.
• Remember to charge the battery monthly while the vehicle is not in regular use.
• Check and tighten all screws and coverings regularly.
• Check all plastic parts for cracks. Replace as necessary.

DASHBOARD INTRODUCTION

Button description
Mode: Switchable Music/ FM/ Bluetooth/ Story; Bluetooth connection: Press the MODE button three times to enter Bluetooth mode, and you can hear the “Waiting to connect” sound. Then select the device named “TOY CAR” on your mobile phone. After being connected, the car can play vour own music.

REMOTE CONTROL INTRODUCTION

• Forward: Direct the ride-on car to move forward
• Backward: Direct the ride-on car to move backward
• Paring: Pair the ride-on car with a remote controller
• Left: Direct the ride-on car to turn left
• Right: Direct the ride-on car to turn right
• Speed: Adjust the speed of the ride-on car’ s movement as low, moderate or high
• Brake: Immediately stop the ride-on car and render it immovable until unlocking

Pairing Instruction

1. Turn on the power of the ride-on car, press and hold the pairing button until the speed indicator light switches on without flashing
2. Release the pairing button, and the speed indicator light will switch off
3. If the speed indicator light switches on again, then the pairing is successful; if not, please repeat steps 1 and 2
4. One successful pairing is all, and no more pairings are needed in later use

Battery installation

• Open the back cover of the remote control with screwdriver and insert two triple A batteries (AAA 1.5V). Please pay attention to the polarity.
• Close the back cover and tighten the screws when the LED light is on, indicating battery installed properly.
• Battery needs to be replaced when the LED light dims or blinks.
• This product does not provide dry batteries.

MAINTENANCE

The vehicle should be checked for damage, missing or badly worn parts before use.

• Check the tightness of the fasteners before each use.
• Check the tightness of the wheels.
• Ensure the battery is securely in place before use.
• Occasionally use lightweight oil to lubricate moving parts such as wheels and steering linkage.
• Do not use oil on plastic or nylon parts. No lubrication is required.
• Store the vehicle indoors or cover it with a tarp to protect it from the wet weather. Keep it away from sources of heat, such as stoves and heaters.
• Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a non-wax furniture polish. Do not use car wax, abrasive cleaners or wash the vehicle with soap and water. Water will damage the motor, electrical system and battery.
• Joywhale recommend you ask professional advice from our technical team if you need maintenance or repair service. Official email address of Joywhale: care@joywhale.com

TROUBLESHOOTING

• care@joywhale.com

CARING FOR YOUR RIDE-ON

• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Do not leave the vehicle in the sun for long periods or fading may occur. Store in the shade or cover with a tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap.
• Charge battery at least once a month to prolong the life of the battery.

If you have any questions about the steps of installing the product or if there are any problems with the product in use, please feel free to contact the customer service of your purchase platform by email.

WARNING
The battery on the vehicle is not replaceable.

• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Non-rechargeable batteries should not be charged.
• Rechargeable batteries should be charged under adult supervision only.
• Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
• Do not put batteries next to or in a heat source(fire, electronic heating device, etc.).
• Do not hit batteries against hard objects.
• Do not submerge batteries in water.
• Batteries should be inserted with the correct polarity.

IMPORTANT

• Always charge battery for 4-6hrs the first time you use it.
• Always charge battery for 8-12hrs after each use.
• Charge the battery once a month, even if you are not using your vehicle.

WARNING
CHOKING HAZARD-Small parts. Not for children under 3yrs. To reduce the risk of injury, adult supervision is requirde. Never use in roadways. Never motor vehicles, on or near steep inclines or steps, swimming poors or other bodies of water; always wear shoes, and never allow more than one rider.

WARNING

• Protective equipment should be worn. Not to be used in traffic.
• The toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third parties.
• To reduce the risk of injury, adult supervision is required. Never use in roadways, near motor vehicles, on or near steep inclines or steps, swimming pools or other bodies of water; always wear shoes, and never allow more than one rider.

WARNING
ADULT ASSEMBLY REQUIRED

WARNING
Not to be used in traffic

FCC STATEMENT

CARING FOR YOUR RIDE-ON

Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following. measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>