THE BUBBLE FACTORY FR2005 Ride On Bumper Car with 360 Rotation Instruction Manual

THE BUBBLE FACTORY FR2005 Ride On Bumper Car with 360 Rotation

Safety Instruction

When using an electrical product, basic safety precautions should always be followed including the following.
Read all instructions carefully before use.

• To protect against electrical shock, do not immerse cord, charger, transformer, battery, or product in water or other liquid.
• Only use charging devices, transformers, and batteries provided or recommended by the manufacturer.
• For your child’s safety, the product should be assembled by an adult.
• This toy is not intended for children below 37 months.
• Close supervision is necessary when your child is using the product.
• Unlatch the battery if not used for a long time.
• Do not use this product as a traffic tool.
• DO not use this product on a public road, raceway, by the swimming pool, or at any potentially dangerous places.
• Do not use this product on slippery surfaces.
• Always keep hands, hair and clothing away from moving parts.
• The maximum user weight for this product is 66 lb / 30 kg.
• Do not change, modify or add any electrical wiring on this product.
• Avoid using this product in a tight environment to prevent damage to the product or injury to the user.
• Do not use this product in the dark. Only operate this product during the daytime or in well-lit areas.
• For your child’s safety, please make sure to fasten the seat belt when using this product.
• A helmet and safety gear are recommended when using this
  To avoid accidents, do not stand on the product. Sitting is the only permissible position when riding in the product.

Note:

1. When charging you must turn off the power switch.
2. It is recommended to charge 4-6 hours before first use, but no more than 10 hours.
3. When the speed of the vehicle is significantly slowed during normal driving, the battery power is insufficient. Please charge it in time.
4. Please charge 8-12 hours after each use, but do not exceed 20 hours.

Instruction Manual

• This product is packed with the battery disconnected.
• Connect the battery before use.
• This manual contains important safety, performance and maintenance information.
• Read the manual carefully before allowing your child to ride your new Ride On Bumper Car toy.
• Keep this manual because it contains important information.

WARNING:
CHOKING HAZARD. Not to children 3 years.

Product Specification

• Motor: 6V/25w•2
• Battery: DC 6V 4.5AH
• Charger. 6V 500mAH / 6V 700mAH
• Speed: 3km/h
• Recommended for ages: 3-8 years
• Maximum user weight: 66 lb / 30 kg
• Dimensions: 696940 cm (LWH)
• Battery charge time: 8 – 12 hours
• First charging time: 4-6 hours
• Max charging time: 10 hours
• Battery (temperature tolerance): 104T
• Battery life: 300 times
• Power mode: rechargeable

Parts and Features

1. Vehicle Body
2. Seat Cover
3. Seat Belt
4. Control Stick
5. Power Button
6. Light Button
7. Horn Button
8. Music Button
9. Charging Port
10. Remote Control

User Instruction

Operating the vehicle

• Press the power switch to turn on the vehicle.
• Push or pull the control sticks to move the vehicle.
• Release the control sticks back to the center position to stop.

WARNING:
Constant close supervision by an adult is needed when your child is operating the vehicle.

Before Use

• Unscrew the screw and remove the seat cover.
• Connect the battery terminal (red to red, black to black).
• Replace the seat cover and tighten the screws.

Charging the battery

• Plug the charger into the charging
• Insert the charger’s power plug into a stable matching AC power as shown above.
• Fully charge the battery for 4-6 hours.
• Do not charge the battery for more than 10 hours.
• Make sure the battery and charger are not damaged. Do not charge if any sign of wear or damage is found.
• To ensure safety, the vehicle must be charged by adults.

The unit will not operate while charging.

• Charge after each use.
• Tum off the power when not in use.

Remote Controller

Features

• Supply voltage: 2 x I .5V
• Frequency: 2450 MHz MHz

Button description

• Forward: Direct the ride-on car to move forward
• Backward: Direct the ride-on car to move backward
• Pairing: Pair the ride-on car with a remote controller
• Left: Direct the ride-on car to turn left
• Right: Direct the car to turn right
• Adjust the speed of the ride-on car’s movement as low, moderate or high
• Brake: Immediately stop the ride-on car and render it immovable until unlocking

Pairing Instruction

1. Turn on the of the ride-on car, press and hold the pairing button until the speed indicator light switches on without flashing.
2. Release the pairing button. and the speed indicator light will switch off.
3. If the speed indicator light switches on again, then the pairing is successful; if not, please repeat steps 1 and 2.
4. One successful pairing is all you need, no more pairings are needed in later use.

FCC

This device complies with part 1 5 of the FCC Rules. Operation is subject to the following two conditions: (1 ) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 Of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment cause harmful interference to radio or television reception, which can be determined by turning the equipment Off and on, the user is encouraged to try to correct the interference by one or more Of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation the equipment and receiver.
• Connect the equipment into an Outlet on a circuit different from that to which the is connected.
• Consult the dealer or an experienced radio,’TV technician for help.

RF Exposure Statement
The device has been evaluated to meet general RF requirements. The device can used in portable exJX)Sure condition without restriction.

Care and Maintenance

• Check the product regularly and make sure there are no missing or lcx)se parts. Re-tighten any lcx»se parts if
• Make sure there are no or broken plastic parts.
• When not using store the product away from any heat source, cover it with a tarp and away from wet weather.
• Turn Off the productand the battery if the product is not in use for a long Period Of time.
• Clean the product with a cloth. Use non-wax furniture polish to restore shine to plastic parts. Do not use abrasive cleaner.
• Do not clean the product with water or wash the product with a hose or immerse any parts in water or other liquid.
• Occasionally use lightweight oil to lubricate moving parts.

Troubleshooting

Fuse Maintenance

This product is equipped with a self-resetting fuse. When the product is overloaded or improperly used. the self-resetting fuse will automatically cut off power for 15-20 seconds and then restart. The self-resetting fuse of this product is installed under the seat. In order to avoid the fuse to cut off the power supply:

• This product cannot be overloaded, the maximum load is 66 lb / 30kg.
• Do not drag anything behind the product.
• Do not allow any water or other liquids to immerse the circuit or any of the electrical components such as batteries.
• Do not change the structure and circuit system of this product without authorization. Any inspection and repair work must be performed by professionals or under the guidance of technical personnel.

WARNING

• Suitable tor ages: 37—95 months.
• Keep away from ‘ire.
• The maximum user weight is 30 kg.
• TO reduce the risk Of injury. adult Supervision is required Never use in roadways. Near motor vehicles. On or near Steep inclines or steps. swimming pools or other bodies Ot water
• Always wear protective clothing and shoes.
• Not to be used in traffic.

PRECAUTIONS

1. Read the assembly & manual use
2. Don’t wash the vehicle with water. only clean it with a dry cloth
3. Assembly of this vehicle must be done by an adult
4. Check the vehicle for The vehicle is not to use until any damage has been repaired/replaced.

Made in Ningbo, China
Product: FR2005
Lot : 112022
IMPORTED BY FLAT RIVER GROUP LLC\ 306 REED STREET
BELDING MI 48809 UNITED STATES

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>