beko HCP61310I Dome Hood User Manual
- June 10, 2024
- Beko
Table of Contents
HCP61310I Dome Hood
User Manual
Please read this manual first!
Dear Customers!
Thank you for selecting a Beko product. We hope that you get the best results
from your product which has been manufactured with high quality and state-of-
the-art
technology. Therefore, please read this entire user manual and all other
accompanying documents carefully before using the product and keep it as a
reference for future use.
If you handover the product to someone else, give the user manual as well.
Follow all warnings and information in the user manual.
Remember that this user manual is also applicable for several other models.
Differences between the models are explicitly described in the manual.
Meanings of the Symbols
Following symbols are used in the various section of this manual:
| Important information and useful hints about usage.
---|---
| WARNING: Warnings for dangerous situations concerning the safety of
life and property.
| Warning for electric shock.
This product has been manufactured in environmentally friendly facilities.
|
---|---
Important safety and environmental instructions
Closely follow the instructions set out in this manual. All responsibility,
for any eventual inconveniences, damages or fires caused by not complying with
the instructions in this manual, is declined. The hood is conceived for the
suction of cooking fumes and steam and is destined only for domestic use.
1.1 General safety
- It is important to conserve this booklet for consultation at any moment. In the case of sale, cession or move, make sure it is together with the product.
- Read the instructions carefully: there is important information about installation, use and safety.
- Do not carry out electrical or mechanical variations on the product or on the discharge conduits.
- Before proceeding with the installation of the appliance verify that there are no damaged all components. Otherwise contact your dealer and do not proceed with the installation.
- Note: the elements marked with the symbol “(*)” are optional accessories supplied only with some models or elements to purchase, not supplied.
- Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply.
- Always wear work gloves for all installation and maintenance operations. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Children shall not be allowed to tamper with the controls or play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. The hood must be regularly cleaned on both the inside and outside (AT LEAST ONCE A MONTH).
- This must be completed in accordance with the maintenance instructions provided in this manual. Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires.
- The flaming of foods beneath the hood itself is severely prohibited. The use of exposed flames is detrimental to the filters and may cause a fire risk, and must therefore be avoided in all circumstances. Any frying must be done with care in order to make sure that the oil does not overheat and ignite.
- CAUTION: Accessible parts of the hood may become hot when used with cooking appliances.
- For lamp replacement use only lamp type indicated in the Maintenance/Replacing lamps section of this manual.
- WARNING! Do not connect the appliance to the mains until the installation is fully complete. With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities.
- The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels.
- Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks.
- Never use the hood without effectively mounted grids. The hood must NEVER be used as a support surface unless specifically indicated.
- Use only the fixing screws supplied with the product for installation or, if note supplied, purchase the correct screws type.
- Use the correct length for the screws which are identified in the Installation Guide.
- In case of doubt, consult an authorised service assistance centre or similar qualified person.
- WARNING! Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
- We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the nonobservance of the instructions included in this manual.
- This appliance is marked according to the European directive 2012/19/ EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product. Appliance designed, tested and manufactured according to:
- Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233.
- Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/ IEC 60704-1; EN/IEC 60704-213; EN/IEC 60704-3; ISO 3741; EN 50564; IEC 62301.
- EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a correct use in order to reduce the environmental impact: Switch ON the hood at minimum speed when you start cooking and kept it running for few minutes after cooking is finished. Increase the speed only in case of large amount of smoke and vapour and use boost speed(s) only in extreme situations. Replace the charcoal filter(s) when necessary to maintain a good odour reduction efficiency. Clean the grease filter(s) when necessary to maintain a good grease filter efficiency. Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise.
1.2 Compliance with WEEE directive and disposing of the waste product
This product complies with EU WEEE Directive (2012/19/EU). This product
bears a classification symbol for waste electrical and electronic equipment
(WEEE).
This product has been manufactured with high quality parts and materials which
can be reused and are suitable for recycling. Do not dispose of the waste
product with normal domestic and other wastes at the end of its service life.
Take it to the collection center for the recycling of electrical and
electronic equipment. Please consult your local authorities to learn about
these collection centers
Compliance with RoHS Directive:
The product you have purchased complies with EU RoHS Directive (2011/65/EU).
It does not contain harmful and prohibited materials specified in the
Directive.
1.3 Package information
Package of the product is made of recyclable materials in accordance with our
National Legislation. Do not dispose of the packaging materials together with
the domestic or other wastes. Take them to the packaging material collection
points designated by the local authorities.
Use
The hood is designed to be used either for exhausting or filter version.
2.1 Ducting version
The hood is equipped with a top air outlet B for discharge of fumes to the
outside (exhaust pipe and pipe fixing clamps not provided). Connect the hood
and discharge holes on the walls with a diameter equivalent to the air outlet
(connection flange). Using the tubes and discharge holes on walls with smaller
dimensions will cause a diminution of the suction performance and a drastic
increase in noise. Any responsibility in the matter is therefore declined.
Attention! If the hood is supplied with carbon liter, then it must be
removed.
2.2 Filter version
In the case of not being able to discharge the fumes and the steam of
cooking outside, the hood in the lter version can be used mounting the F
deflector on the flue and one or more carbon filters (on the basis of the
model possessed). The fumes and steam are recycled into the kitchen through
upper grill H.
Attention! If the hood is not supplied with carbon liter, then it must be
ordered and mounted.
The models with no suction motor only operate in ducting mode, and must be
connected to an external suction device (not supplied).
The connecting instructions are supplied with the peripheral suction unit.
Installation
Fig. 3
The minimum distance between the supporting surface for the cooking equipment
on the hob and the lowest part of the range hood must be not less than 65 cm
from electric, gas or mixed cookers. If the instructions for installation for
the hob specify a greater distance, this must be adhered to.
3.1 Electrical connection
The mains power supply must correspond to the rating indicated on the plate
situated inside the hood. If provided with a plug connect the hood to a socket
in compliance with current regulations and positioned in an accessible area,
after installation.
If it not fitted with a plug (direct mains connection) or if the plug is not
located in an accessible area, after installation, apply a double pole switch
in accordance with standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in accordance
with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains cable is
correctly assembled.
Warning! Power cable replacement must be undertaken by the authorised
service assistance centre or similar qualified person.
Mounting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
Operation
The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking.
Cleaning and maintenance
6.1 Cleaning
Clean using ONLY the cloth dampened with neutral liquid detergent. DO NOT
CLEAN WITH TOOLS OR INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
6.1.1 Grease filter
Traps cooking grease particles.
The grease filter must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be set to a low
temperature and a short cycle. When washed in a dishwasher, the grease filter
may discolour slightly, but this does not affect its filtering capacity. To
remove the grease filter, pull the spring release handle. Fig. 1
6.1.2 Charcoal filter (filter version only)
Fig. 2
It absorbs unpleasant odor rs caused by cooking. The saturation of the
charcoal liter occurs after more or less prolonged use, depending on the type
of cooking and the regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least every four
mounts. The charcoal filter may NOT be washed or regenerated. Remove the
grease filters. Fit the charcoal filters over the motor. Align the pins R on
the cowl with the slots S, then turn the filter clockwise until it locks in
place. Reverse the above procedure to remove the
charcoal filters. Refit the grease filters.
6.2 Maintenance
6.2.1 Replacing lamps
Fig. 1
Disconnect the appliance from the electricity.
Warning! Prior to touching the light bulbs ensure they are cooled down.
Replace the old light bulb with the one of the same type as specified in the
feature label or near the light lamp on the hood. Remove cover A to access the
lamp housing A.
If the lights do not work, make sure that the lamps are fitted properly into
their housings before you call for technical assistance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>