renkforce 2498315 8 Port Patch Panel Instruction Manual

renkforce 2498315 8 Port Patch Panel

Product Information

The 8-port patch panel with 0.5U CAT 6A is used for indoor purposes only and is not intended for outdoor use. It is an RJ45 patch panel that comes with 8 sockets and has a length of 254 mm (10 inches). The product is not a toy and should be kept out of reach from children and pets. The contact with moisture must be avoided.

Product Usage

1. Handling: The product should be handled with care as jolts, impacts or falls can cause damage.
2. Operating Environment: The product should not be placed under any mechanical stress, extreme temperatures, strong jolts, flammable gases, steam, and solvents. It should be protected from high humidity, moisture, and direct sunlight. Do not switch on the product after it has been taken from a cold to a warm environment.
3. Anschluss und Montage: Connect the patch panel to the network cables by plugging them into the sockets of the patch panel. Mount the patch panel on a rack or wall using screws.
4. Zuordnung der Pins: The pins are assigned as follows: Pin 1 – Brown, Pin 2 – Brown, Pin 3 – -, Pin 4 – -, Pin 5- -, Pin 6 – -, Pin 7 – -, Pin 8 – -.
5. Cleaning and Maintenance: To clean the product, use a dry, lint-free cloth. Do not use any solvents or cleaning agents.
6. Disposal: Dispose of the product in accordance with local regulations and laws.

For further information and troubleshooting, refer to the operating instructions provided with the product. Improper use of the product can lead to short circuits, fires, or other hazards. If you have any questions or concerns, please contact our technical support service or other technical personnel.

Intended use

• The product is intended for use as an RJ45 patch panel.
• The product is intended for indoor use only. Do not use it outdoors.
• Contact with moisture must be avoided under all circumstances.
• If you use the product for purposes other than those described, the product may be dam-aged.
• Improper use can result in short circuits, fires, or other hazards.
• The product complies with the statutory national and European requirements.
• For safety and approval purposes, you must not rebuild and/or modify the product.
• Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions.
• All company names and product names are trademarks of their respective owners. All rights reserved.

Delivery contents

• Product
• Operating instructions

Latest product information
Download the latest product information at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.

Description of symbols

The symbol warns of hazards that can lead to personal injury. ****

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

General

• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
• If you have questions which remain unanswered by this information product, contact our technical support service or other technical personnel.
• Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.

Handling

• Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.

Operating environment

• Do not place the product under any mechanical stress.
• Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
• Protect the product from high humidity and moisture.
• Protect the product from direct sunlight.
• Do not switch the product on after it has been taken from a cold to a warm environment. The condensation that forms might destroy the product. Allow the product to reach room temperature before you use it.

Operation

• Consult an expert when in doubt about the operation, safety or connection of the product.
• If it is no longer possible to operate the product safely, take it out of operation and pro-tect it from any accidental use. DO NOT attempt to repair the product yourself. Safe op-eration can no longer be guaranteed if the product:
  • is visibly damaged,
  • is no longer working properly,
  • has been stored for extended periods in poor ambient conditions or
  • has been subjected to any serious transport-related stresses.

Connected devices

• Also observe the safety and operating instructions of any other devices which are con-nected to the product.

Connection and installation

Important:

• In case of doubt, do not perform installation yourself; leave it to a professional.
• For cabling use either the colour coding according to T568A or T568B (in Europe T568A is usually used).
• Do not mix the two colour codes on your network, or otherwise the network connec-tions may not work.
• For information about the Pin assignments and coding information, refer to section: Pin assignments [} 3]

– In case of doubt, do not perform installation yourself; leave it to a professional.
– For cabling use either the colour coding according to T568A or T568B (in Europe T568A is usually used).
– Do not mix the two colour codes on your network, or otherwise the network connec-tions may not work.
– For information about the Pin assignments and coding information, refer to section: Pin assignments [} 3]

Pin assignments

Cleaning and care

Important:

• Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
• Do not immerse the product in water.

1. Clean the product with a dry, fibre-free cloth.

Disposal

This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.

Technical data

• Contact resistance …………………….. max. 100 mΩ
• Insulation resistance ………………….. min. 1000 mΩ, 500 V/DC
• Dielectric strength ……………………… 750 V/AC RMS, 60 Hz, 1 min
• Transmission rate ……………………… 10 Gbit/s
• Ports ……………………………………….. 8x RJ45 (fully shielded)
• Cable Ø …………………………………… 5.0 – 8.5 mm (outer)
• LSA terminal code …………………….. T568A/B
• Material ……………………………………. SPCC, thickness: 1.5 mm
• Wire Ø …………………………………….. 1/0.4 -1/0.65 mm (AWG 26/1 -22/1) 7/0.20 -7/0.16 mm (AWG 24/7 -26/7)
• Standards ………………………………… ISO/IEC 11801:2002 Class EA ISO / IEC EN 50173 ClassEA EIA / TIA 568-C Cat.6A IEC 60603-7-5
• Support ……………………………………. PoE IEEE 802.3af, PoE+ IEEE 802.3at
• Connection service life ………………. min. 750 mating cycles (RJ45) min. 200 mating cycles (insulation displacement terminals)
• Operating conditions ………………….. 10 to +60 °C, 10 – 85 % RH
• Storage conditions …………………….. 20 to +75 °C, 10 – 85 % RH
• Dimensions (W x H x D ……………… approx. 255 x 100.8 x 22.2 mm
• Weight …………………………………….. 594 g

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2498315_V1_1222_dh_mh_en 732982795-2 I1/O1 en

References

• Conrad Electronic » Your Sourcing Platform
• Conrad Electronic » Your Sourcing Platform
• Download center

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>