SEALIFE SportDiver Smartphone Housing Pre-Dive Checklist Instructions
- June 10, 2024
- SeaLife
Table of Contents
SEALIFE SportDiver Smartphone Housing Pre-Dive Checklist
Product Information
This product is a piece of diving gear and requires proper testing, preparation, and maintenance before use. It is recommended to pack spare parts such as o-rings, lube, Moisture Muncher, and batteries for essential items.
Product Usage Instructions
- Test your gear: Before your trip, make sure to test all your diving gear to ensure it is functioning correctly.
- Pack spares: Pack spare parts of essential items such as o-rings, lube, Moisture Muncher, and batteries to avoid any inconvenience during the dive.
- Prepare yourself: Review the manual and maintenance instructions thoroughly to prepare yourself for the dive.
- View Pre-Dive Checklist Video: Before the dive, make sure to view the Pre-Dive Checklist Video to ensure you have all the necessary gear and follow the correct procedures.
By following these instructions and properly maintaining your diving gear, you can have a safe and enjoyable diving experience.
INSTALLATION INSTRUCTIONS
-
TEST all your gear before your trip.
-
PACK SPARES of essential items like o-rings, lube, Moisture Muncher, and batteries.
-
PREPARE yourself by reviewing the manual and maintenance instructions.
Before your Dive: -
CHARGE your phone battery.
-
CHECK housing batteries and Moisture Muncher are in place; DO NOT TOUCH moisture sensor.
-
CLEAN & LUBE housing and check port o-ring, use a thin coating of lube.
-
SET the PHONE to Airplane mode: ON; Bluetooth: ON; Do not Disturb: ON.
-
CLEAN phone display screen, and lenses and lens port of the SportDiver Housing, re-move any phone cover or case.
-
POWER ON the housing and open the SportDiver app.
-
PLACE the PHONE in the HOUSING & SEAL it, allow it to adjust to outside temperature, then apply specified pressure using vacuum pump.
-
CHECK online Troubleshooting if you experience any problems.
After your Dive: -
SOAK & RINSE the SportDiver housing in fresh water pushing all buttons to flush out any salt water.
-
DRY the SportDiver housing using a towel, making certain the housing and you are completely dry.
-
RELEASE vacuum pressure, while making sure no water is present under the check port cap.
-
OPEN the housing with the lens facing up to avoid any drops from getting inside the housing
-
POWER OFF the housing,
-
STORE the housing in a cool, dry place with the door slightly open (unlatched)
View the Pre-Dive Checklist Video
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>