Tidoin OVS-2181 Modern 1.28 GPF One Piece Toilet Instruction Manual
- June 10, 2024
- Tidoin
Table of Contents
OVS-2181 Modern 1.28 GPF One Piece Toilet
Instruction Manual 
OVS-2181 Modern 1.28 GPF One Piece Toilet
INSTALLATION INSTRUCTIONS
MODERN 1.28 GPF ONE PIECE TOILET
Model OVS-2181
Complies with ASME Al 12.19.2/CSA 8125.1-2013.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE
WITH CARE!
**RECOMMENDED TOOLS AND MATERIALS
**
Putty Knife
Regular Screwdriver
Adjustable Wrench
Sealant
Tape Measure| Hacksaw
Wax Ring/Gasket
Flexible Supply Tube
Closet Bolts
Carpenters Level
---|---
-
REMOVE OLD TOILET (IF NEW INSTALLATION PROCEED TO STEP 2
a. Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line.
NOTE: If replacing valve, first shut off main water supply!
C. Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be dean and level before new toilet is installed! -
DIMENSIONS (Nominal)
NOTE: Distance from wall to closet flange
centerline (rough-in) must be IF (305 mm) minimum. -
INSTALL CLOSET BOLTS
Install closet bolts in flange channel,
turn 90i, and slide into place 6″ (152 mm) apart and parallel to wall. -
INSTALL WAX RING
Invert toilet on floor (cushion to prevent
damage), and install wax ring evenly around waste flange (horn), with tapered
end of ring facing toilet. Apply a thin bead of sealant around base flange. -
INSTALL TOILET ON FLANGE
a. Remove waste covering and install toilet
on closet flange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts.(Larger diameter side of washers (Marked “THIS SIDE Ur) must face up!) -
INSTALL TOILET
a. Position toilet squarely to wall and, with
a rocking motion, press bowl down fully on wax ring and flange. Alternately
tighten nuts until toilet is firmly seated on floor. CAUTION: DO NOT
OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If needed, cut bolt height to size before installing caps.) Place a bead of sealant around base. Remove excess sealant. c. Smooth off the bead of sealant around base. Remove excess sealant. -
CONNECT WATER SUPPLY
a. Connect water supply line between shutoff
valve and tank water inlet fitting. Tighten coupling nuts securely. b. Turn on
supply valve and allow tank to fill until float rises to shutoff position. c.
Check for leakage at fittings, tighten or correct as needed. -
INSTALL TOILET SEAT
Install toilet seat in accordance with enclosed directions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>