Glatz AURA Majestic Wooden Parasol Instruction Manual

June 10, 2024
GLATZ

Glatz AURA Majestic Wooden Parasol

Glatz AURA Majestic Wooden Parasol-FIG1

Product Information

  • Product Name: AURA
  • Available Sizes: 350 x 350 cm, 400 x 400 cm
  • Ground Space: 12.3 m2 for 350 x 350 cm, 16.0 m2 for 400 x 400cm
  • Length of Course: 220 cm
  • Total Height: 297 cm for 350 x 350 cm, 305 cm for 400 x 400cm
  • Material: Eucalyptus wood frame with fabric canopy

Product Usage Instructions

Assembly and Installation
  1. Unpack the parasol and make sure all parts are included (parasol with crank, tie strap).
  2. Place the parasol on a flat surface.
  3. Prepare the ground anchor.
  4. Rotate the safety pin upwards and pull the standpipe out of the mast. Position the orientation notch towards the canopy section. Do not remove the black slide disk.
  5. Insert the standpipe back into the mast, rotate the safety pin downwards, and lock the standpipe in place.
  6. Attach the canopy to the standpipe and securely tighten it.

Usage

  • To release the sliding arm, lightly loosen and pull it out while simultaneously pushing the slider up. Then secure the slider.
  • To tilt the canopy, adjust the desired angle by sliding the slider up, tilting the canopy to the desired angle, and securing the slider.
  • To rotate the canopy, rotate the safety pin upwards, rotate the canopy using the crank, and rotate the safety pin downwards.

Maintenance and Cleaning

  • For preventive maintenance of the wooden frame, clean it with a fine, clean damp cloth 1-2 times per year depending on the level of dirt and environmental conditions.
  • Avoid using abrasive cleaners or solvents, as they may damage the wood finish.

Disassembly

  • Remove the canopy from the standpipe and secure it with a tie strap.
  • Rotate the safety pin upwards and pull out the standpipe from the mast.
  • Disassemble and store all parts in a dry place.

Disposal

  • Dispose of all parts in accordance with your local regulations.

Welcome
Congratulations on the purchase of your new AURA. You have purchased a high- quality parasol. These instructions form part of this product. It contains important safety, usage and disposal information for users of the product. Please familiarise yourself with all the informa-tion listed before using the product. The product may only be used as described herein and for the use scenarios stated. If you continue to use it and care for it properly, your AURA parasol will serve you well for many years to come.

Optional accessories

A high-quality range of accessories is included with your parasol: It includes, among other things, the following products, which go perfectly with your parasol:

  • Base
  • Mounting plate
  • Ground Socket
  • Protective cover
  • OSYRION Spot
    Consult your GLATZ dealer about this.

Technical data

Glatz AURA Majestic Wooden Parasol-FIG2

Warranty

Please contact your GLATZ partner before returning the product. The warranty on the parasol lasts for 24 months from the date of purchase. The warranty expires in the following cases:

  • External application of excessive force
  • Inappropriate operation or maintenance of the parasol
  • Damage arising from force majeure

The wind guarantee for an open parasol is limited. The maximum permissible wind speeds always require a fixed anchorage in the ground. If there are several parasols, a minimum distance of 20 cm must be maintained between any two of them. Likewise, a minimum distance of 20 cm must be maintained between the parasol and walls.

Intended use

The product serves as a device for the protection of the human body from solar radiation. The product may only be used in private households, in the catering and hotel sector or in a comparable environment. The product may only be used in accordance with these installation and operating instructions. Any use other than the uses described in these installation and operating instructions shall be considered improper use. We reserve the right to make modifications due to technical advances. In these instructions the AURA may also be referred to as ‘the product’ or ‘parasol’.

Warning words used

  • DANGEROUS Immediately dangerous situation which can result in death or severe injuries.
  • CAUTION Potentially dangerous situation which can result in minor or moderate injuries.
  • NOTICE A situation that can lead to property damage.

Safety information

READ ALL THE SAFETY INFORMATION CAREFULLY AND MAKE SURE THAT YOU UNDERSTAND THEM.

  • Follow all the instructions to avoid accidents, fire, explosions, electric shock or other hazards that could cause property damage and/or severe or fatal injuries.
  • Ensure that each person using the product has read and observes these warnings and instructions.
  • Keep these installation and operating instructions for the future. It must be passed on to subsequent users of the product.
  • The manufacturer is not liable for material damages or injuries caused by incorrect use or the failure to observe the safety instructions. The warranty becomes invalid in such cases.
  • The protective effect against hazardous UV radiation varies depending on the environment. Additional measures to protect your skin are possibly also necessary.
  • Children must not play with the product.
  • !DANGER Always keep children away from packaging material – this constitutes a choking hazard. Children underestimate risks. This product is not a toy.
  • Children aged 8 years or over and persons with reduced physical, sensory or mental capabilities, lack of experience or knowledge may only use the appliance if they are supervised by a person who is responsible for their safety or if they have been shown how to use the appliance safely and they have understood the risks inherent in its use. Cleaning and maintenance tasks may not be carried out by children without supervision.
  • Do not use the device if you are suffering from a lack of concentration /attention or under the influence of drugs, alcohol or medication.
  • The product must be placed in a base or a ground sleeve that is firmly anchored.
  • Do not allow the product to fall or knock against anything.
  • Check the span of the parasol before opening/closing it.
  • Make sure there are no persons/objects in the movement area when opening/closing it. Otherwise, injuries/damage may occur.
  • !DANGER Close the parasol when the wind picks up, in stormy weather conditions and/or when snow is falling.
  • Observe the specifications concerning the maximum permissible wind speed for a fixed ground anchorage (ground sleeve inserted in concrete). The permissible wind speed is reduced if a different anchorage method is used.
  • Unattended parasols may not remain opened. Any damage is not covered by the warranty. Always secure closed para-sols with a binding belt.
  • Only use original accessories / spare parts.
  • Product and technical modifications are not permitted.
  • The parasol must be monitored during opening and closing.
  • Check parasol and accessories regularly to be sure that no undue wear and tear or damage has occurred. If defects are found, have them repaired before further use.
  • Do not use any solvents or abrasive cleaning agents.
  • Dismantled parasols should only be stored lying down.
  • When using a fixed floor anchorage, the installation must be performed by specially trained persons in accordance with the separate installation instructions.
  • Do no ignite a naked flame in the proximity of, or under, the parasol.

Installation and start-up

  1. Unpacking the parasol Supplied with:

    • parasol with crank (ready assembled)
    • binding
    • protective cover
    • 5 fastening screws
    • 5 support screws
    • Allen key
    • Operating instructions
      Dispose of packaging material prop-erly and keep away from children. Do not make use of defective ma-terial. In the event of any damage, inform the transport service provider immediately.
  2. Placing the parasol down

  3. Spread out on a woollen blanket.

  4. Place the parasol upon it.
    Carefully place the parasol on a clean, horizontal surface. The parasol is very heavy. Work in a threesome and hold the parasol securely.

  5. Prepare the floor fastening
    Place the floor fastening in accordance with the separate instructions.

  • maximum wind speed when it is securely anchored in the ground.

Glatz AURA Majestic Wooden Parasol-FIG3

  1. Check the standpipe

  2. Turn the locking pin upwards

  3. Pull out the stand pipe from the mast

  4. Remove any plastic film

  5. Position the orientation notch towards the parasol part

  6. Reinsert the stand pipe

  7. Turn the locking pin downwards

  8. Lock the standpipe into place.
    The orientation notch must face towards the parasol part. Do not remove the black sliding washer.

  9. Preassemble the parasol

  10. Place the parasol with the standpi-pe on the base

  11. Align the cutout/position

  12. Insert the washers completely into the recesses

  13. Insert 2 opposite screws and screw them tight
    The parasol is very heavy. Work in a threesome and hold the parasol securely.

  14. Fixing the parasol in place

  15. Turn the locking pin upwards

  16. Carefully turn the parasol

  17. Insert 2 further screws and screw them tight

  18. Turn the parasol once more

  19. Insert the last screw and screw it tight

  20. Turn the parasol into the original position

  21. Turn the locking pin downwards

Glatz AURA Majestic Wooden Parasol-FIG4

Use

  1. Prepare to open

  2. Remove protective cover

  3. Detach strap

  4. Detached the slide by means of rotary knob

  5. Before winding up: lightly loosen/remove the ribs by hand

  6. Opening the parasol

  7. Completely open the parasol through use of the crack and at the same time push the slide upwards

  8. Secure the slide once more
    Detach the rotary knob on the slide to a sufficient extent that the slide can be moved freely.

  9. Tilting the parasol roof

  10. Detach the slide by means of rotary knob

  11. Set an appropriate parasol incline

  12. Secure the slide once more.

  13. Turning the parasol
    The parasol can be tilted in 45° steps

  14. Turn the locking pin upwards

  15. Turn the parasol by means of the pivoted lever

  16. Turn the locking pin downwards

  17. The parasol locks into place in the next 45° position

  18. Closing the parasol

  19. Detached the slide by means of rotary knob

  20. Crank it anticlockwise, at the same time pull slide downwards

  21. Pull the bracket on the mast

  22. Secure the slide once more
    Keep the parasol as compact as possible.

  23. Bind/protect the parasol

  24. Pull out / wrap fabric segments

  25. Secure the parasol with a binding strap

  26. Lift the protective cover above the parasol section

  27. Close the protective cover
    Position the rod on the mast side of the parasol.

Handling and maintenance

  • Allow the parasol to dry when open to prevent the formation of mould and discolouration.
  • A protective sleeve protects the parasol and will extend its service life.
  • Only pull the protective sleeve over the dry parasol when it is dry.
  • Do not clean the protective sleeve in the washing machine. Do not use chemicals.
  • Clean the parasol cover when needed with lukewarm water, fine detergents and a sponge.
  • Do not use any bleach or sharp objects, to avoid damage to the cover.
  • Check the tightness of all screws from time to time and tighten them if necessary.
  • If the parasol is located in a highly exposed position, increased wear and tear must be expected. In such cases we recommend more intensive care and maintenance.
  • In most cases, defective parasols can be repaired by your GLATZ partner. Only use original replacement parts FROM GLATZ.

Disassembly

Dismantle the parasol if it is not going to be used for a long time. DANGER! DANGER OF TIPPING DANGER OF INJURY IF THE PARASOL TOPPLES OVER

  1. Close and tie the parasol properly.
  2. Dismantle the parasol in reverse mounting direction.
  3. Store the parasol in lying position together with all accessories in a dry place.

Disposal

This symbol on the product, accessories or packaging indicates that the product must not be treated as unsorted domestic waste but must be disposed of separately. Dispose of the product at a designated recycling collection point.
The packaging is made of environmentally friendly materials that can be disposed of at your local recycling facilities. By disposing of the product correctly, you will help to avoid possible environmental and health hazards. The product is made of metal and synthetic parts. End-of-life disposal must be carried out in accordance with regional environmental and waste regulations.

Wood maintenance

Please observe the following:

  • Always sand along the grain of the wood.
  • The AURA frame is made of eucalyptus wood, which is a hardwood. Please take this into account when selecting an oil.

Preventative maintenance of the wooden frame (1–2 times annually, depending on the environment and level of contamination):

  1. Remove the canopy from the frame to prevent contamination or oil stains on the fabric. If only the mast needs maintenance, the canopy does not need to be removed. However, ensure that the oil/sand paper does not come into contact with the canopy.
  2. Clean the frame (mast and struts) with a fine, clean, damp cloth and then let dry.
  3. Lightly sand the frame (mast and struts) with sandpaper for wood in 240 grit.
  4. Remove any sanding dust from the surface.
  5. Rub the frame (mast and struts) with a fine, clean, oiled cloth and then let it dry for at least one hour. Oil cut edges and cut surfaces especial-ly well.
  6. Wipe the frame (mast and struts) with a fine, clean, dry cloth.
  7. If necessary, reattach the canopy to the frame.

Treating damage (e.g. scratches, nicks, mouldy spots, etc.):

  1. Remove the canopy from the frame to prevent contamination or oil stains on the fabric. If only the mast needs treatment, the canopy does not need to be removed. However, ensure that the oil/sand paper does not come into contact with the canopy.
  2. First sand the damaged/affected area with sandpaper for wood in 80 grit.
  3. Sand the entire affected part (mast and/or strut) with sandpaper for wood in 120 grit.
  4. Remove any sanding dust from the surface.
  5. Rub the entire affected part (mast and/or strut) with a fine, clean, oiled cloth and then let it dry for at least one hour. Oil cut edges and cut surfaces especially well.
  6. Lightly sand the entire affected part (mast and/or strut) with sandpa-per for wood in 240 grit.
  7. Rub the entire affected part (mast and/or strut) with a fine, clean, oiled cloth. Take care not to use too much oil. Allow it to dry for ap-prox. 15 minutes and then rub the area again with a cloth.
  8. If necessary, reattach the canopy to the frame.

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals