SATEC HEPS Hall Effect Power Supply Module User Guide

June 10, 2024
SATEC

HEPS Module Quick Start Manual
SATEC Hall Effect Power Supply (HEPS) Module for Direct Current Applications

HEPS Hall Effect Power Supply Module

SATEC HEPS Hall Effect Power Supply Module

Figure 1: HEPS front plate and wiring terminals
**** Mounting, electrical connection and settings of the HEPS Module shall be made in accordance with all applicable laws and/or regulations and be performed by authorized personnel only.

ELECTRICAL INSTALLATION

Install the HEPS module on a DIN-rail, close to an appropriate AC power supply. Wire L to phase and N to neutral current.
Each Hall Sensor must be connected to power supply via 3 wires, +, – and 0.
When using the HEPS as power supply, wire + to +, – to – and 0 to 0.

SATEC HEPS Hall Effect Power Supply Module- fig

HEPS MODULE CHARACTERISTICS

  • Power supply: 100-250V AC
  • Output: ±15V DC

TECHNICAL SPECIFICATIONS

Input Ratings

  • Voltage: 90-264V AC (50/60Hz)
  • Burden: 30 VA
  • Terminals: 2 X 7.5mm
  • Wire Size: 1.5-0.25mm2

Output

  • Voltage: ( ;-15 ;0 4 X ± 15V DC +)15 +)
  • Power: 1.5W per each

Environmental

  • -40°C to 60°C / -40°F to 140°F

SATEC DEVICES

SATEC products supporting DC metering and use of HEPS:

  • EM235 (PRO)
  • PM335 (PRO)
  • PM130
  • PM135

Copyright © 2021 SATEC Ltd.
www.satec-global.com
HEPS QuickStart

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals