BLADE BLH5450 150 S BNF Basic Helicopter Instruction Manual
- June 4, 2024
- BLADE
Table of Contents
Instruction Manual
Bind Addendum for Blade Helicopters with the SPMAR6250MHX Receiver This
product requires an approved Spektrum DSM2®/DSMX® compatible transmitter.
Refer to the Transmitter Setup Table to correctly set up your transmitter.
RTF
Your RTF transmitter comes prebound to the model. If you need to re-bind,
follow the directions below.
It is possible to bind this model with a bind plug or use the invert-to-bind
method.
General Binding Procedure
- Lower the throttle stick to the lowest position. Set all trims to the center position.
- Power off the transmitter (RF off for iX transmitters) and move all switches to 0 positions. Move the throttle to the low/off position.
- Insert the bind plug into the bind port extension cable on the side of the helicopter.
- Connect the flight battery to the ESC. The LED on the receiver will flash orange rapidly when it enters bind mode.
- Press the bind button and power on your transmitter (iX series transmitters put the transmitter into bind mode).
- Release the bind button after 2–3 seconds. The helicopter is bound when the LED on the receiver turns solid orange.
- Disconnect the flight battery and remove the bind plug.
Invert to Bind Procedure
- Lower the throttle stick to the lowest position. Set all trims to the center position.
- Power off the transmitter (RF off for iX transmitters) and move all switches to the 0 positions. Move the throttle to the low/off position.
- Connect the flight battery to the ESC.
- Flip the model upside down and hold for 15s. The LED on the receiver will flash orange rapidly when it enters bind mode. Turn the model upright and set it down.
- Press the bind button and power on your transmitter (iX series transmitters put the transmitter into bind mode).
- Release the bind button after 2–3 seconds. The helicopter is bound when the LED on the receiver turns solid orange.
- Disconnect the flight battery.
©2022 Horizon Hobby, LLC.
Blade, the Blade logo, DSM, DSM2, DSMX, Spektrum AirWare, and ModelMatch are
trademarks or registered trademarks of Horizon Hobby, LLC.
The Spektrum trademark is used with permission of Bachmann Industries, Inc.
All other trademarks, service marks, and logos are the property of their
respective owners.
US 9,930,567. US 10,419,970. Other patents are pending.
463850
BLH12001/BLH1200/BLH4550/BLH5850
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>