trimline V191121 Install Wide Trims Instructions
- June 10, 2024
- trimline
Table of Contents
**trimline V191121 Install Wide Trims
**
Install Wide Trims
WARNING
The wide trims trims cannot be retrofitted
Exercise care when removing the wide trims and accessories from their packaging to avoid scratches.
The set contains the following items
- Wide trims.① ② ③
- Self-drilling screws and spacers ④
- Brackets ⑤ for clamping the wide trims. ③
Trim line 63H Front
Trim line 73 Front
Trim line 73H Front/Tunnel
Trim line 100 Front/Tunnel
Trim line 120 Front/Tunnel
Trim line 140 Front/Tunnel
Trim line 170 Front
Trim line 38 Corner Left/Right
Trim line 63 Corner Left/Right
Trim line 100 Corner Left/Right
Trim line 120 Corner Left/Right
Trim line 140 Corner Left/Righ
Trim line38 Panoramic
Trim line 63 Panoramic
Trim line 100 Panoramic
Trim line 120 Panoramic
Trim line 140 Panoramic
Trim line 73 Room Divide~
Trim line 85 Room Divider
For other languages, download the manual, open it in Acrobat Reader and choose the desired language with the buttons on the bottom side of this page
STEP 1
Place the top frame trim ① on the finishing edge on the front panel on the stove ① . Centre the trim accurately relative to the centre of the stove (drawing), align the top trim with the front trim edge. In the case of stoves with predrilled fixing holes, secure the upper trim using the screws and spacers provided. Do not over tighten the screws, the trim needs to be able to slide.
In the case of stoves with no predrilled fixing holes, the top frame trim ① must be fastened to the existing front panel using the self-drilling screws. After pre-drilling with the self-drilling screws, remove the front panel from the appliance and drill a 5mm hole in the convection box ② . Refit the front panel and fasten the top frame trim using the screws and spacers Do not over tighten the screws, the trim needs to be able to slide.
CAUTION
In the case of the Trim line 63H F, 73 F and 73H T models, the 2 vertical glazing bars ③ must be removed before fitting the side trim ③· These glazing bars are no longer required
STEP 2
Loosen the left-hand and right-hand hexagon socket head screws that secure the bottom glazing bar. Fit the left-hand and right-hand trims; they hook behind the top wide trim. ① Fit the brackets ⑤ on the left and right, slide them against the wide trims and retighten the hexagon socket head screws. ④
STEP 3
CAUTION
Work carefully to avoid damaging the wide trims.
The wide trims ② can now be positioned between the side trims ③·
CAUTION
The built-in construction may not make contact with the wide trims due to expansion of the stove when hot.
While fitting the remaining refractory material, ensure a clearance gap of a few millimeters to the wide trims. The finishing edge on the frame surrounds the glass. ⑤
Customer Support
