bimar FE-45A Floor and Wall High Speed Fan Instruction Manual

FE-45A Floor and Wall High Speed Fan
Instruction Manual
Type VS58 (mod. FE-45A)

FE-45A Floor and Wall High Speed Fan

Please read these instructions carefully before using the appliance, and instruct other persons using it, too, when necessary. Keep booklet and for further use.
If when reading this instructions manual certain parts should remain difficult to understand, or if there is any confusion, contact the company indicated on the last page before using the product.
This symbol highlights instructions and precautions for safe use. Warnings and appliance installation, use, cleaning and maintenance procedures may be updated slightly from those described in this manual; for further details, please consult the updated on-line manual at www.bimaritaly.it.

GENERAL NOTICES

• This device is intended for home use only, to ventilate internal rooms, and in the manner described in this manual: do not use it for any other purpose. Any other use is to be considered inappropriate and therefore dangerous. The manufacturer cannot be held responsible for eventual damage caused by inappropriate, improper or irresponsible use and/or for repairs made to the product by unauthorised personnel.
  This appliance is intended to be used in household and similar applications such as:
  – staff kitchen in shops, offices and other working environments;
  – farm houses
  – by clients in hotels, motels and other residential type environments
  – bed and breakfast type environments

• Do not touch the appliance with wet hands or feet.

• Do not insert any tool, or your fingers, into the grille protecting the blades.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

• The appliance must be kept out of children’s reach.

• Ensure that the fan is switched off from the supply mains before removing the guard.

• Attention: when using electric appliances, the basic safety precautions must always be observed to avoid risks of fire, electric shocks and physical injury.

• Do not use the appliance if it is not operating correctly or seems damaged; if in doubt, contact professionally qualified personnel.

• Always unplug the appliance before you assemble, disassemble or make adjustments to the appliance.

• Make sure that the appliance is working correctly: if not, turn the appliance off and have it checked by professionally qualified personnel.

• Do not move the appliance when it is operating.

• Unplug the appliance when not in use.

• Do not use the device at room temperatures above 40 °C.

• Do not move the appliance when it is in function.

• Do not leave the device exposed to the weather (sun, rain, etc.).

• Do not pull on the cord to disconnect the plug from the socket.

• If the electric cord is damaged, it has to be replaced by the supplier or an authorized service center or a professionally qualified, to avoid any risks.

• Do not use the appliance with a timer or a programmer or with a system that can switch on the appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or positioned incorrectly.

• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally qualified help: repairs made by unqualified persons can be dangerous and render void the warranty.

INSTALLATION

• After removing the packing materials, check the integrity of the heater; if you are unsure, do not use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children because they are potential sources of danger. Attention: any stickers or advertising material applied to the grid removed before using the appliance. The manufacturer declines all responsibility in case this is not safe working practices will be respected.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of your electricity and that the electric plug is grounded. In the event of incompatibility between the electric outlet and the plug of the appliance, have the outlet replaced with another more suitable type by professionally qualified personnel, who will make sure that the section of the wires of the outlet is appropriate for the absorbed power of the appliance. In general, the use of adapters or extension cords is not recommended; if their use is indispensable, they must conform to existing safety standards and their current capacity (amperes) must not be less that the maximum of the appliance.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum distance of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.

Wall installation

• The appliance must only be used if secured to a wall: the wall must be flat, smooth, very stable (as the appliance could tip over) and resistant.
• Position the appliance far from other sources of heat, inflammable materials, curtains, carpets, etc., inflammable gases or explosive materials (spray cans).
• If the appliance is fitted to a wall, the same must be made of masonry and/ or of resistant material (not of wood or synthetic material); follow the indications below for installation:
  – The wall fan must be installed at least 2 m above the floor (below picture)
  – Fix two hooks to the wall (at a distance, below picture n.3), make the holes on the wall, inserting the hooks into the slots provided with screws.
  – Attach the appliance on the wall with hooks; once completed, ensure the fan is securely installed onto the wall.

Portable installation (on a surface/table)
Place the unit on a flat and stable surface, make sure that the area in front is clean and dustfree. USE Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person with similar qualifications, in order to avoid any risk.

• The fan can be manually adjusted up and down by the air grating and according to his inclination.
• Verify that the switch is in pos.off, then insert the plug of the fan in the power supply.
• Select the desired speed with the selector. 1 – Minimum speed 2 – Medium speed 3 – Maximum speed

To turn the fan off, press the “0” key and then remove the plug from the socket.
When not in use for long periods, the plug must always be removed from the socket.

CLEANING AND MAINTENANCE

Attention: before normal cleaning, remove the plug from the socket.

• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your hand in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make sure that all the electrical parts are dry: in the case of doubt, ask for professionally qualified help.
• It is essential that the motor’s air holes be kept from dust and lint.
• If the fan will not be used for long periods, it must be protected from dust and humidity; we recommend storing it in its original packaging.
• Should you decide not to use the appliance any more, we recommend making it inoperative by cutting the power cord (after making sure you have disconnected the plug from the socket) and make dangerous parts harmless if children are allowed to play with them (such as the blade).

DISPOSAL

Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), the crossed bin symbol on the appliance or its packaging indicates that the appliance must be disposed of separately from other waste at the end of its useful life. The user must therefore take the appliance to an appropriate recycling centre for electrical and electronic equipment. Alternatively, instead of handling the disposal, the user can hand over the appliance to the retailer when a new, equivalent one is purchased. The user can hand over electronic products measuring less than 25 cm to retailers of electronic products having a sales area of at least 400 m2 free of charge and with no obligation to buy. Appropriate separate collection for the subsequent procedure for the decommissioned appliance for recycling, which includes treatment and environmentally friendly disposal helps prevent adverse effects on the environment and health and promotes reusing and/or recycling materials that the appliance consists of.

Information requirements

n.206/2012

Via G.Amendola, 16/18
25019 Sirmione (BS) – ITALY
www.bimaritaly.it
Customer care:
Assistenza.privati@bimaritaly.it

References

• Small Bimar appliances. Quality and Design.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>