ACREO OpenBuds Kids Next Generation Open Ear Headphones for Kids User Manual
- June 10, 2024
- ACREO
Table of Contents
The Next Generation Open Ear
Headphones for Kids
Model: OpenBuds Kids
User Manual
Package Contents
Function Instructions
- LED Indicator
- Touch area
- Type-C Charging Port
- HeadBand with Memory Steel Wire
Touch Control Instructions
| Power on | Press and hold ” ” for 5 seconds |
|---|---|
| Power Off | Press and hold ” ” for 5 seconds |
| Play/Pause | Press ” ” 1 times |
| Next Track | Press ” ” 2 times |
| Previous Track | Press ” ” 3 times |
| Volume + | Press ” ” 4 times |
| Volume – | Press ” ” 5 times |
| Answer/Hang up | Short press ” ” 1 time when calling |
| Reject to Answer the Call | Press ” ” for 2 seconds during incoming call |
| Restore factory settings | Short press ” ” for 2 times continuously |
Quick Start Guide
-
When using the OpenBuds Kids for the first time, please power on the headphones via touch and hold for 5 seconds, the headphone will automatically come into the pairing mode.
-
If the product is in pairing mode, it will display”ACREO OpenBuds Kids” as the Bluetooth name on the smartphone, please select and connect.
-
After being connected successfully, it will be ready to play music, make calls, and so on.
Note: When the headphone is not in the connection status for more than 5
minutes, the headphone will automatically shut down.
LED
indicator Instructions：
Pairing Mode–Red and blue light flash alternately
Connected Mode–Blue light flashes 1 time at 5 seconds interval
How to Charge the Headphone
Make sure the headphone is fully charged before first use.
- The headphone has a built-in li-on battery, which must be charged at least once every 2 months if it is not used for a long time.
- Use the USB type C cable to charge the headphone, you can use any USB power input 5V 500mA adapter included, and the computer USB port is fine.
- When charging, the headphone will automatically shut down, and the indicator light shows below
Charging instructions:
When charging indicator light, red light is steady on.
When fully charged, turn on the blue light.
Restore factory settings
If the headset is stuck or other functions cannot be used normally, you can click ” ” red and blue lights on twice for 3 seconds, the red and blue lights will flash alternately, and the headset will be restored to factory Settings.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
