LiquidLEDs Festoon String Light User Guide
- June 9, 2024
- LiquidLEDs
Table of Contents
Liquid LEDs Festoon String Light User Guide
www.liquidleds.com.au
help@liquidleds.com.au
02 8880 9033
SAFETY INFORMATION
Ensure to read all instructions and warnings in this user guide before first use. Retain this user guide for future reference.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed,
including the following:
⚠ READ AND FOLLOW ALL SAFETY INSTRUCTIONS
- Do not mount or place near gas or electric heaters, fireplace, candles, or other similar heat sources.
- Do not secure the product’s wiring with staples or nails or place it on sharp hooks or nails.
- Do not let lamps rest on the supply cord or on any wires.
- Do not hang objects from the cord, wire, or light string.
- Do not use this product for other than its intended use.
- Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
- Do not cover the product with cloth, paper or any material not part of the product when in use.
- Read and follow all instructions on the product or provided with the product.
- Ensure the power cord is unplugged before installing, connecting, or when replacing the light bulbs.
- Do not replace the light bulbs during rain or when the string light is wet.
⚠ CAUTION: RISK OF ELECTRIC SHOCK Do not use extension cord near water or where water may accumulate. Keep lamps at least 16 feet (4.88m) from pools and spas. Keep plugs and receptacles dry. Do not submerse.
⚠ WARNING: RISK OF ELECTRIC SHOCK Disconnect power at the source prior to wiring, re-lamping or servicing in any way. The light string kits are supplied with an two prong plug that will only fit into a Australian outlet. Do not alter the plug.
Connecting Multiple Sets:
Add the wattage of each light bulb together for a total of 2000 Watts or less.
DO NOT EXCEED 2000 WATTS
When multiple connecting sets protect connection(s) from direct exposure to rain and water. Do not allow connection(s) to become wet.
Connecting String Lights
Installation
Installation Methods
- Using a guide wire with S-hooks or cable ties
- Attached to a structure
Troubleshooting
NOTE: If certain bulbs will not light, unplug the string light from the outlet and check the contact inside the socket (brass contact at the center of the socket). It may be necessary to raise the contact point somewhat to ensure elidable contact with the base of the bulb. Ensuring power is off, bend the contact upwards with a small flat-head screwdriver (no more than 25-30 degrees).
Maintenance
Periodically clean the string light, check connections and ensure no additional weight has been added.