Innovative Design Works WNST-3 Winston Workstation Quad with Compact Worksurface Instruction Manual
- June 4, 2024
- Innovative Design Works
Table of Contents
CompuCaddy
Works WNST-3 Winston Workstation Quad with Compact Worksurface
Instruction Manual
Innovative Ergonomic Solutions
800 524 2744
customerservice@team-ies.com
team-ies.com
HAT Collective
408 437 8770
cs@hatcollective.com
hatcollective.com
CAUTION:
** Mechanisms can rise quickly with no equipment in place. User equipment
must be properly installed, prior to height adjustment. Failure to do so may
result in personal injury and/or property damage. NOTE:
Depending on your Winston Workstation® configuration, you may not receive all
the parts shown within this instruction booklet. Installation may require two
people.
Depending on your Winston Workstation® configuration, you may not receive
all parts** shown below.
Parts List
* Included with Winston Workstation Triple
only.
** Included with Winston Workstation Quad only.
IMPORTANT: Do not pull excessively on the cable – doing so may result in
accidental actuation of the column.
CAUTION: Do not press the height to adjust button until the unit is fully
assembled.
ARE YOU
INSTALLING WINSTON WORKSTATION TRIPLE?
IF NOT, PLEASE CONTINUE TO STEP 18.
ARE YOU INSTALLING WINSTON
WORKSTATION QUAD?
IF NOT, PLEASE CONTINUE TO STEP 24.
IS YOUR HEIGHT ADJUST BUTTON NOT WORKING?
17a If so, make the adjustments below.
Slide the workstation so that the worksurface hangs over the desk edge to
allow access to underneath the worksurface.
17b Loosen the two screws as shown.
17c Slide bracket in the direction shown and tighten screws.
17d Test height adjusts button – readjust by repeating the steps above as
necessary.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>