OVERSTEEL Iridium RGB Gaming PC Case White User Manual
- June 9, 2024
- OVERSTEEL
Table of Contents
OVERSTEEL Iridium RGB Gaming PC Case White
TECHNICAL SPECIFICATIONS
| MODEL | IRIDIUM |
|---|---|
| DIMENSIONS {L x W x H) | 332mm x185mm x 413mm |
| WEIGHT | 3,5Kg |
| MATERIAL | Steel 0,4mm SPCC, tempered glass |
| FANSLOCATION | Front: 3x 120mm |
Rear: lx 120mm (lx A-RGB included)
Top: 2x 120mm
WATER COOLING| Front: up to 240mm radiator
Rear: up to 120mm radiator
DRIVE BAYS| 2x 2,5″ + 2x 3,5″/2,5″
EXPANSION SLOTS| x7
FRONT I / O| USS 3.0 xl
USS 2.0 x2
Headphone/Microfone xl
Power
Reset
DUST FILTER| lxTop
lx Bottom
MOTHERBOARD TYPE| ATX, MicroATX, ITX
POWER SUPPLY| ATX up to 180mm (not included) bottom position
VGA{GPU)| Up to 300mm (not included)
CPUCOOLER| Up to 155mm (not included)
DIMENSION
PC CASE GENERAL DIAGRAM
- Magnetic dust filter
- Side tempered glass
- Back metal side
- 120mm RGB fan
- PSU enclosure bay
- HDD/SSD Enclosure Bay
- Front panel I/O
- PCI expansion bays
FRONT PANEL I/O AND MOTHERBOARD CONNECTORS
ACCESORY BAG
-
Motherboard standoffs
-
Motherboards /SSD Screws
-
PSU Screws
-
HDD Screws
-
Zip ties
-
HDD Enclosure screws
BASIC INSTALLATION
A. Disassemble the side panel and the front panel
B. Install the power supply
C. Install the motherboard
D. Install HDD/SSD
E. Install GPU and expansion slot (PCI)
F. Install fan and radiator (optional)
Disassemble the side panel and the front panel
Take out the screws before disassembling side panel.
Remove the side panels before disassembling the front panel.
Special attention to the tempered glass side panel. Handle with care.
Install the power supply
Make sure the screw holes for PSU and the PC case are aligned before screwing.
Install the motherboard
Make sure that the motherboard aims at the copper cylinder and install the standoffs (No.1) before screwing in with the No.2 screws.
Install HDD/SSD
- Use the screws (6) together with the rubber bands and screw 3 of them to the base of the hard disk. Mount the hard drive by aligning these screws with the holes in the top of the bay. Once in place, use the stop screw to secure it.
- Use the screws (4) to fix it to the base of the bay.
Use the screws (2) to secure the SSDs.
Install GPU and expansion slot (PCI)
Remove the baffle marked in the picture, make sure the VGA card aims at the motherboard slot and then fix VGA card and case with No.3 screw.
Install fan and radiator (optional)
A| FRONT| Fans → 3x 120mm
Radiator up to 240mm
---|---|---
B| TOP| Fans → 2x 120mm
C| REAR| Fans → 1x 120mm
Radiator up to 120mm
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>