HT MOSTAR PALI M4 Remote Control User Manual
- June 9, 2024
- HT MOSTAR
Table of Contents
HT MOSTAR PALI M4 Remote Control
Product Information
- Product Name: PALI M4 remote control T4HU2049 35kA
- Brand: HT Mostar
- Country of Origin: Designed in Europe, Made in China
- Compatibility: TV and Set Top Box
- Battery Type: Not specified
Product Usage Instructions
- Turn ON your TV and your Set Top Box.
- Remove the Pali M4 remote control from the plastic bag.
- Remove the remote’s battery lid.
- Place the batteries on the Pali M4 remote control as indicated in the image above and replace the battery lid.
- Wait for a few seconds after inserting the batteries for the Pali M4 remote to be ready to operate the Set-Top-Box.
Pali M4 BLE Remote Contro
Turn On Pali M4
Pali M4 remote control arrives inside a polybag. To turn on your Pali M4 remote control, please follow the instructions below.
- Turn ON your TV and your Set Top Bo
- Remove your Pali M4 remote control from the plastic bag.
- Remove the remote’s battery lid.
- Place the batteries on the Pali M4 remote control as indicated in the image above and replace the battery lid.
- After inserting the batteries, wait a fewseconds and the Pali M4 remote will be ready to operate the Set-Top-Box.
FCC
FCC Compliance Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
To comply with FCC regulations, please:
- Avoid using this product near other devices that may cause interference.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televison reception, which can be determined by turning the equipment off an on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Warning
- Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- Risk of explosion if the battery is replaced by an incorrect type.
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery that can result in an explosion.
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
CAUTION
- Risk of explosion if the battery is replaced by an incorrect type;
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
- Temperature range: 0º – 50ºC
- Altitude : up to 3000 feet
MANUFACTURER
Tech4home, Lda Rua de Fundões N.º 151, 3700-121 São João da Madeira, Portugal
NAMEPLATE LOCATED ON THE BATTERY COMPARTMENT
T4HU2049 35kA Pali M4 DESIGNED IN EUROPE YEAR/MONTH/DAY MADE IN CHINA
MAC: XXXXXXXXXXXX
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>