Elontess TDS9 Mini 3 In 1 Wireless Microphone System User Guide
- June 9, 2024
- Elontess
Table of Contents
Elontess TDS9 Mini 3 In 1 Wireless Microphone System User Guide
Package Content
Instruction
- 0pen the charging case, TX/RX will automatically power on and connect automatically;
- If the blue light is always on, it means the connection is successful, and ifthe blue light flashes slowly, it means the connection is unsuccessful; If the TX/RX connection is unsuccessful, it will automatically shut down after 5 minutes;
- If the TX/RX connection is u nsuccessfu I, just put it back into the charging case and close it and then open the case to automatically connect.
Transmitter (TX) To clip on the collar
Receiver (RX) To plug into the mobile
The receiver adopts a replaceable interface design, and all three types of
connectors are compatible ,ReplaceableAll in One Compatibility with
mobile,Tablet and Cameras
TX/RX can be charged after putting it in the Charging Case. The red light turns on for 3 seconds and then goes out.
When the blue light is always on, it means it is charging. When TX/RX is fully charged, the blue light will go out
When the external power supply is chargingthe charging case, the red light flashes slowly to indicate that it is charging, and the red light is always on when it is fully charged.
Product Parameters
-
Wireless Transmission Mode: 2.4GHz adaptive frequency hopping
-
Transmission Range: 80m
-
Polar Pattern: Omnidirectional
-
Microphone Sensitivity: -38dB ± ldB(1dB=1V/Pa@1 KHz)
-
Microphone Distortion: <0.1%
-
Microphone Sample Rate: 48KHz
-
Frequency Response: 20Hz-20KHz
-
Product Dimensions: TX:35.3•17.821.1mm
RX:61.416.5#14.1m m (Adapter is not included) -
Charging Case: 95.253.253mm
-
Net Weight: TX:8.2g
RX:10.6g -
Charging Case: 110.8g
-
Battery Capacity: TX:100 mAh
-
Charging Case: 1500 mAh
RX:100mAh -
working Current: TX:20mAh
RX:20mAh -
Operating Time: About 5 hours
Charging TX and RX 2.5 times at the same time -
Charging Time: About 1 hour
Charging Case:About 1.5 hours
Safety Guidelines
- Keep out of reach of children when charging
- Store this product away from dust, do not store it in a hum id environment for a longtime
- When idle for a longtime, it is recommended to charge the battery once a month to avoid reducing battery life due to long-term storage
- Do not throw this product to avoid falling damage, do not suffer from water droplets, or place it in a container with liquid
- Do not use sharp objects to scratch or expose to the sun, and do not approach exposed fire sources
Warranty Card
User/Organization name :
**Contact:Tel:_
Order Number :__
Purchase Date** :_____
| Date | After-sales Record | Recipient |
|---|
Product list: charging boxtl, receiverl, transmitter”2, replaceable pluC3, windproof ca p”2, charging cable-1, storage bars, manual’s
The schematic diagram used in this manual is for reference only, the actual product may be different from it, and the actual product in the package shall prevail
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
FCC ID: 2BAC8—TDS9
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>