PHILIPS SCY100-02 Avent Anti-Colic Baby Bottle User Manual
- June 4, 2024
- Philips
Table of Contents
PHILIPS SCY100-02 Avent Anti-Colic Baby Bottle
Read all instructions carefully before use. Keep the user manual and product packaging for future reference.
For your child’s safety and health
WARNING!
- Continuous and prolonged sucking of fluids will cause tooth decay.
- Always check food temperature before feeding.
- Throw away at the first signs of damage or weakness.
- Keep components not in use out of the reach of children.
- Never attach to cords, ribbons, laces or loose parts of clothing. The child can be strangled.
- Never use feeding teats as a soother. – Always use this product with adult supervision.
It is not recommended to use a microwave to warm up baby food or drinks. Microwaves may destroy valuable nutrients in food/drinks and may produce localized high temperatures. If you decide to use the microwave, take extra care to stir heated food/drinks to ensure even heat distribution and check the temperature before serving. Only place the container in the microwave, without the screw ring, teat and cap. Do not allow children to play with small parts or walk/run while using bottles. Always discard any breast milk that is left over at the end of a feed. Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage or weakness.
Before first use
Disassemble all parts, clean and then sterilize the parts by placing in boiling water for 5 minutes or sterilize by using a Philips Avent sterilizer. This is to ensure hygiene.
Assembly
Make sure that you place the cap vertically onto the bottle so that the teat sits upright (see image for more details). The teat is easier to assemble into the screw ring if you move it back-and-forth while pulling it upwards instead of pulling it up in a straight line.
Cleaning and storage
Clean all parts before each use to ensure hygiene. After each use, disassemble all parts, wash in warm, soapy water, remove any food residues and rinse thoroughly. Then sterilize using a Philips Avent sterilizer or boil for 5 minutes. Make sure that you wash your hands thoroughly and that the surfaces are clean before contact with sterilized components. During sterilization with boiling water, prevent the parts from touching the side of the pot. This can cause irreversible product deformation, defect or damage that Philips cannot be held liable for. Food colorings may discolor parts. This product is dishwasher safe. Do not place the product in a heated oven. Do not bring the bottle parts in contact with or place on surfaces with abrasive or antibacterial cleaning agents. We recommend replacing feeding teats every 3 months. Keep feeding teats in a dry, covered container. Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant (sterilizing solution) for longer than recommended, as this may weaken the teat.
USING
- Philips Avent Anti-colic baby bottle
- Philips Avent milk storage container
- Philips Avent trainer cup
- Philips Avent breast pump
Compatibility
Replacement teats are available separately. Make sure that you choose the correct teat corresponding to the screw ring of your bottle: teats from the Philips Avent Anti-colic range only fit in screw rings of the Philips Avent Anti-colic range. To learn more about choosing the right teat for your baby, visit us at www.philips.com/avent. The Philips Avent bottle is compatible with most Philips Avent breast pumps, spouts, sealing discs and cup tops.
Support
If you need information or support, please visit
www.philips.com/support.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>