PHILIPS SCF798 Avent Straw Cup User Manual

: June 4, 2024
: Philips

Table of Contents

Assembly
Documents / Resources

Avent
SCF798
SCF796

PHILIPS SCF798 Avent Straw Cup - 1

PHILIPS SCF798 Avent Straw Cup - 2

Read all instructions carefully before use. Keep the user manual and product packaging for future reference.
For your child’s safety and health
WARNING!

Continuous and prolonged sucking of fluids will cause tooth decay.
Always check food temperature before feeding.
Throw away the first signs of damage or weakness.
Keep components not in use out of the reach of children.
Never attach to cords, ribbons, laces, or loose parts of clothing. The child can be strangled.
Always use this product with adult supervision.

It is not recommended to use a microwave to warm up baby food or drinks. Microwaves may destroy valuable nutrients in food/drinks and may produce localized high temperatures. If you decide to use the microwave, take extra care to stir heated food/drinks to ensure even heat distribution and check the temperature before serving. Only place the container in the microwave, without other parts. Do not allow children to play with small parts or walk/run while using bottles or cups. Thick, fizzy, pulpy drinks or formula milk may block the valve and cause it to break or leak. To prevent scalding, allow hot liquids to cool down before you fill the cup. Do not interchange the straw cup parts with a glass bottle.
Before first use

Remove the disposable straw cover from the straw before you use the bottle for the first time and throw it away. The disposable straw cover is packaging material and is only intended to ensure hygiene during transport.
Disassemble all parts (Fig. 1A), clean, and then sterilize the parts by placing them in boiling water for 5 minutes or sterilize by using a Philips Avent sterilizer. This is to ensure hygiene.

Assembly

Make sure that the straw cup parts are properly assembled (Fig. 1B). Close the screw top tightly by turning it clockwise. Otherwise, it may come off during use. Do not overtighten the lid on the straw cup.
To drink from the straw cup, open the lid by flipping the cap to the back.
Cleaning and storage
Clean all parts before each use to ensure hygiene. After each use, disassemble all parts, wash in warm, soapy water, remove any food residues and rinse thoroughly. If necessary, clean the straw with a straw cleaning brush. Then sterilize using a Philips Avent sterilizer or boil for 5 minutes. Make sure that you wash your hands thoroughly and that the surfaces are clean before contact with sterilized components. During sterilization with boiling water, prevent the parts from touching the side of the pot. This can cause irreversible product deformation, defect or damage that Philips cannot be held liable for. Food coloring can discolor parts. This product is dishwasher safe. Do not place the product in a heated oven.
Do not bring the cup parts in contact with or place them on surfaces with abrasive or antibacterial cleaning agents. Cups are suitable for all common sterilization methods. For safety and hygiene reasons, replace straws after 3 months of use. Use only Philips Avent straws. For hygiene and maintenance, disassemble the straw cup completely (Fig. 1A) and store it in a dry and covered container. Keep the straw cup away from heat sources and direct sunlight. Do not store the straw cup in drying/sterilizing cabinets with heating elements.
Compatibility
For replacement parts, please visit www.philips.com/support or contact your local Consumer Care Center. Mix and match Philips Avent bottle and cup parts and create the product that works for you, when you need it (Fig. 2).
Support
If you need information or support, please visit www.philips.com/support.

www.philips.com/avent
Philips Consumer Lifestyle B.V.
Tussendiepen 4, 9206 AD Drachten,
The Netherlands / Holandija
Trademarks are the property of Koninklijke Philips N.V.
© 2021 Koninklijke Philips N.V.
All rights reserved.
4213.354.3882.4 (03/09/2021)