Fotopro BT-2 Bluetooth Remote Control Mini Mobile Pictures and Selfies Device User Guide
- June 9, 2024
- Fotopro
Table of Contents
BT-2 Bluetooth Remote Control Mini Mobile Pictures and Selfies Device
User Guide
BT-4
Specifications
Remote control model ：BT-2
Chip model ：YC1089X
Size: L 38.5 x W 28 x H 11mm Weight: 6.5g (Within battery)
Features: Support IOS11.4.1 and Android 5.1.1 or above
Power supply: Built-in 3.0V/1632 button cell
Bluetooth 4.2 BLE
Bluetooth protocol: HCI
Working voltage: 3.0V(button cell )
Working current: keystroke current is 2.5mA, first stage sleep
is 0.5mA(no operation), second stage sleep is 2uA
Effective distance: remote control distance up to 10 meters
ISM frequency band: 2400MHz– 2483.5 MHz
Operation
On
- Put the button to “ON”
- The Bluetooth remote will start the automatic pairing state after the machine is turned on
Off
Put the button to “OFF”
Connection of Bluetooth remote
Search name: BT-2
When the indicator light is flashing, means the Bluetooth remote is being
paired. Then you can search BT-2 on your phone. The indicator light is not
flashing once the Bluetooth remote has connected your phone
Shooting
After the Bluetooth remote connected with the phone, to change your phone to
“shooting” model, then press the shutter of remote is ok to take the photo.
Attention:
The Bluetooth of your phone must be open during working.
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1)This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 0cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>