CLASSICBIKE RAISCH BMW R9T Fork Cap Instruction Manual

June 9, 2024
CLASSICBIKE RAISCH

CLASSICBIKE logo

CLASSICBIKE RAISCH BMW R9T Fork Cap

CLASSICBIKE RAISCH BMW R9T Fork Cap

Mounting instruction BMW R9T fork cap (RSU fork)

  1. Jack up the front of the vehicle / relieve the load completely.
  2. loosen clamping of upper triple clamp!!!!!!!!!!!
  3. unscrew original fork caps. Tip: a plastic bag or paper towel between tool and fork cap. Attention, the fork spring presses from the inside against the fork cap. Don’t be afraid, but please expect some counterpressure.
  4. Important, put the O-ring from the original fork cap on the new fork cap!
  5. Put some fork oil on the thread and the o-ring (wipe off some oil from the inside of the fork with your finger)
  6. Screw on the new fork cap. Wrench size 26mm. Tip: use our plastic nut (available in our store). Tightening torque according to BMW 22NM. Here hand-tight (15NM) is sufficient, a torque wrench is not required.
  7. if the fork cap is not aligned in the desired position, the clamping of the lower triple clamp must also be loosened and the fork leg can then be rotated to get the desired alignment. Attention, do not change fork tube position in height. Tightening torque lower triple clamp 19NM
  8. tighten upper triple clamp again with 19NM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals