anko 43226382 3 In 1 Mop and Bucket Set User Manual
- June 9, 2024
- Anko
Table of Contents
- anko 43226382 3 In 1 Mop and Bucket Set User Manual
- 360° SWIVEL HEAD MOP TECHNOLOGY
- MOP ASSEMBLY
- 3 IN 1 MOP AND BUCKET SET
- PATENTED THREE-CHAMBER SEPARATION TECHNOLOGY
- CLEANING PREPARATION
- CLEANING PREPARATION
- SYSTEM PARTS
- SYSTEM PARTS
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
anko 43226382 3 In 1 Mop and Bucket Set User Manual
360° SWIVEL HEAD MOP TECHNOLOGY
360° Rotating head to help reach those tough areas
Wet or Dry Usage: Perfect for home, kitchen, bathroom, office, corner
cleaning. Use wet for a deep clean or use dry for dusting floors, ceillings,
windows, and other surfaces
MOP ASSEMBLY
-
Insert the three plastic tongues into the corresponding pad sleeves, pull over bottom of mop head to opposite side, and insert other set of tongues.
-
Press the grey tabs back into place to secure the pad. Insert the stainless steel mop pole into the mop head.
Screw middle mop pieces onto bottom rod attachment (2 pieces). -
Screw top soft grip handle onto top middle mop piece.
-
Congratulations! You have assembled your mop.
3 IN 1 MOP AND BUCKET SET
PATENTED THREE-CHAMBER SEPARATION TECHNOLOGY
The bucket separates dirty from clean water providing you with the cleanest floor
CLEANING PREPARATION
Step 1: Push two sidesbuttons open lid. Add clean water and your avourite
detergent into the clean water reservoir.
Step 2: Insert lid onto bucket and make sure the 2 grey release buttons are
firmly locked into place.
Step 3: Turn white knob to addclean water into the middle reservoir to start
cleaning(3/4 full s recommended at the start).
Note: Avoid filling the center chamber all the way to prevent oversaturation.
Use more or less water based on your particular floor type and for washing and
drying your floor.
CLEANING PREPARATION
Step 4: Swivel to change direction of pad so both ends get saturated.
Note: When starting only half of the mop pad may become saturated. This is
normal when starting and the pad will become fully saturated after the first
few scrubs.
Step 5: Start mopping! The 360- swivel head will help with all the tough
areas.
Repeat Step 4 To clean and moisten mop pad.
-Repeat Step 3 When water in middle reservoir starts to run low.
-When finished, pull out black plug at bottom of mop bucket to remove dirty water.Open the lid to clean the whole bucket.Remove mop pad and place in the washer/dryer.
SYSTEM PARTS
SYSTEM PARTS
Three Chamber bucket lid
Three Chamber bucket