NEO LITE 07905L Estrelas Smart Solar Ground Light User Guide
- June 9, 2024
- NEO LITE
Table of Contents
NEO LITE 07905L Estrelas Smart Solar Ground Light User Guide
TECHNICAL PARAMETERS
- Communication protocol: Bluetooth
- Solar panel: polycrystalline silicon 5V/3W
- Battery: 18650, Lithium battery 3.7V/2200mAh
- Type and number of LEDs: 4*8pcs, LED2835
- Charging time: 4-5 hours
- Working time:10-12 hours
- Degree of protection:IP65
- Function: light control by app
- Chromaticity: RGB
- Material: ABS + PC + stainless steel
Before installing the solar luminaire, read the instructions carefully. And follow the instructions given. Allow the solar luminaire to charge sufficiently in sunlight for at least 4-6 hours before using it for the first time. The luminaire will charge during the day and automatically light up after dark. If the solar lantern is not working properly or the working time is short, place it directly in the sun and let it charge for 2 days in direct sunlight. Do not switch on the solar lamp during this process. The battery should be fully charged.
NOTICE
- Install the product preferably where there are no trees, gutters or other obstructions that could block sunlight. If the solar panel does not have enough sunlight, it will affect the shining time.
- Do not install the product under other light fixtures. Lighting generated by other fixtures may cause the product to malfunction or flicker.
- The product has a light sensor, use it where there is no light.
- Rainy, foggy, or cloudy weather will affect lamp charging, working time will be shortened.
- The performance of the solar reflector depends on the environment, latitude, seasons, etc.
- Install the product preferably in places where there are no trees, gutters, and other obstacles that could block sunlight. If the solar panel does not have enough sunlight, it will affect the shining time
- The solar spotlight contains batteries, please recycle the batteries in accordance with the relevant laws and regulations of the user‘s country or region.
- Do not immerse the solar panel in water
MAINTENANCE
In order to allow the PV panel to receive maximum solar radiation, keep the solar panel clean by wiping it with a soft, damp cloth. Avoid abrasive and cleaning agents!
PRODUCT MANUAL
- CW &WW model: Press switch first, turn on at 100% brightness, press switch a second time, half brightness, hold switch for 3 seconds, turn off.
- Press switch first, RGB changes gradually, press second time, fix green light, press third time, fix red light, press fourth time, fix blue light.
- Intelligent model: press the switch to open the light, then control the device through the app on your mobile phone.
LIGHT CONTROL
Switches on automatically when the light turns on Cycle switching Charges by
the sun during the day.
INSTALLATION STEP
- Connect the cable connector in order between the lamp body and the light, then turn the waterproof cap tightly.
- Place the cable, then insert the light into the ground.
- In-ground installation mode: choose an open place without shadow, then place the pin of the panel body into the ground.
- Wall installation mode: Drill a hole in the wall at the distance of the hole in the base, then use screws to fix it.
SYMBOLS
Manufacturer and importer: WPB CZ, 703, 742 85 , Czech Republic.
www.immax.cz
www.immax.eu