HOTO B09VN15WT1 Zoomable Rechargeable LED Flashlight Instruction Manual
- June 9, 2024
- HOTO
Table of Contents
HOTO B09VN15WT1 Zoomable Rechargeable LED Flashlight Instruction Manual
Stay tuned to our social media (@hoto official)
Product Overview
Read this manual carefully before use, and retain it for future reference. Thank you for using HOTO flashlight Lite
- Diffuser
- Focus Ring
- Main Switch
- Strobe/SOS switch
- Hook
- Indicator Light
- Type-C charging port
How to Use
Focusing
Push the focus ring up and down to achieve the effect of focusing and flooding
Main Switch
- Daily use: short press to turn it on (low light mode by default). Short press again to adjust to medium light mode; again to high light mode; and again to shut it down. Repeat the operation.
- During charging: Short press to turn it on to low light mode; short press again to shut it down. Repeat the operation.
Strobe/SOS switch
- Short press to turn on the strobe mode; short press again to switch to SOS mode; short press again to shut down; Repeat the operation.
- The strobe mode: in this mode, high-frequency flashing and strong light stimulation can be used to disturb the line of sight of any potential perpetrators for defense.
- SOS mode: in this mode, the flashlight automatically flashes with three dits, three dats, and three dits to signal for help to the outside world.
Indicator status
Operating status
- Battery is above 60%: green light is on
- Battery is between 30%-60%: orange light is on
- Battery is between 10%-30%: red light is on.
- Battery is less than 10%: red light flashes. (Attention: Atter the red light flashes for a while, the main lamp of the flashlight will flash and be forced to turned off in about 2 minutes. In that case, please charge the device.)
Charging status
- Charging: red light breathes;
- Fully charged: green light is on.
This flashlight is equipped with a Type-C charging port, and a USB charging cable is included.
General Power Tool Safety Warnings
Safety matters
-
Correct use
Please use the tool properly as guided in this document. -
Maintenance service
This product cannot be disassembled. Only the maintenance personnel authorized by our company can repair the product. Please do not repair it yourself to avoid possible harms. -
Charging instructions
- Only use the charger that is in line with the charging parameters of the tool for charging;
- If the status indicator does not display normally when it is not used for a long time, please continue to charge for 30 minutes and check it again.
Instructions for use
- This product can emit strong light. Please avoid having it emit direct light to human, animal eyes and optical equipment lens;
- In order to reduce the risk of harm, children should use the flashlight when with their parents;
- To reduce the risk of electric shock, do not put the tool in water or other liquids;
- Do not place or store the tool where it may fall into the bathtub or sink;
- Atter the strobe mode is turned on for a long time, the focus ring may generate high temperature. To reduce the risk of burns, please do not touch it.
Warning
-
Please use a charger that is in line with the charging parameters of the tool for
charging. Other types of chargers and accessories may violate the product warranty and may cause danger. -
15 minutes ater the highlight mode is turned on, the temperature will increase
by about 20°C. For users who are sensitive to temperature, please implement heat insulation measures. (Ater 25 minutes, the temperature will slowly decrease.) -
Ater the product detects that the battery reaches 45°C, it will trigger the charging protection function and stop charging. The recommended charging environment temperature is 0℃-30℃.
General malfunction and troubleshooting methods
Issue | Possible Causes | Solution |
---|---|---|
Press the main switch or strobe/SOS switch, the red light flashes. | Low li-ion | |
baery power | Charging | |
Press the main switch or strobe/SOS switch, the flashlight does not light up. | ||
No li-ion baery power | Charging | |
The indicator light on the main switch does not light up during charging | The | |
USB cable is not plugged in, or the specified charging cable is not used. | Use |
the specified charging cable; use 5V power adapter; check whether the indicator light is on.
Specifications
Model: QWSDT001
Item Dimensions: 164.5x 30 x 30 mm
Net Weight: Approx.160 g
Input: 5V 1A
Battery Type: Lithium-ion battery
Battery Capacity: 2600 mAh
Rated Voltage: 3.65V
Charging Time: Approx.210 min
Main switch three-mode parameters
| High light mode| Medium light mode| Low light mode
---|---|---|---
Brightness| 1000LM| 350LM| 50LM
Run time| 2H| 3.5H| 24H
Manufactured by: Shanghai HOTO Technology Co., Ltd.
Address: Building 45, No.50 Moganshan Road, Putuo District Shanghai,
China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>