CANOPIA AH-15 Waterproof Outdoor Carbon Fiber Heater with Wall-Ceiling Mount Instruction Manual
- June 8, 2024
- CANOPIA
Table of Contents
AH-15 Waterproof Outdoor Carbon Fiber
Heater with Wall-Ceiling Mount
Instruction Manual
1500W
110 -120 V ~ 60Hz 1500W Model.: AH-15 – North America
1800W
220-240V ~ 50Hz 1800W Model.: AH-18 – Europe / UK
PARTS REQUEST
In the case of missing or damaged parts, do not return product to store.
Go to the link below or scan the QR code for help, it will direct you to a
form that will help us assist you as soon as possible.
Contact us on our website:
ASSEMBLY ASSISTANCE
If you need any technical assistance in assembling your product, go to the
link below or scan the QR code for help.
It will direct you to a form that will help us assist you as soon as possible.
Contact us on our website:
CUSTOMER SUPPORT
WE ARE HERE TO HELP
For general questions: bit.ly/3kY07dP
USA
877-627-8476
hobbyservice@poly-tex.com
CANADA
905-5646007
sales@footprintproducts.com
UNITED KINGDOM • IRELAND
01302-380775
customer.serviceUK@palram.com
NORWAY
+972-4-848-6816
customer.service@palram.com
ELECTRIC IP65 WATERPROOF OUTDOOR CARBON FIBER HEATER WITH WALL/CEILING
MOUNT
CAUTIONS
-
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present. -
The heater must not be located immediately below a socket-outlet.
-
Do not use this heater with a programmer, timer or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
-
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
-
Do not place the unit close to curtain and/or other flammable objects.
Otherwise there will be a danger of catching fire. -
Do not cover the unit with anything during operation or a short time after it’s shut down.
-
Do not wrap the power supply cord on the unit.
-
Do not use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
-
Do not use this unit as a cloth drier or towel drier.
-
Do not use this unit as a sauna heater.
-
Do not use this unit as a room heater of heat storing.
-
Do not use this unit in place of animal propagating and raising.
-
Do not use this unit in heating system of hot air centre.
-
Do not immerse this unit into water for cleaning.
-
The unit is at high temperature during operation. It keeps hot for a period after shut down. Potential danger would occur when touching it during this period.
-
The unit must be handled with care, and avoid of vibration or hitting.
-
The unit must be securely grounded during operation.
-
When damaged, the unit must be repaired by professional repairing team.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
When assembling, keep clear from any board or flammable material.
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
-
The unit is for household use only. It’s not allowed to use in building site, greenhouses, barn or stable where there’s flammable dust.
-
The head of the unit is at high temperature during operation. Unplug the unit and wait till it’s cool before cleaning.
-
The unit should be plugged in a socket, which is easily visible and reachable.
WARNING
This heater is not equipped with a device to control the room temperature. Do
not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is
provided.
PREPERATION
-
Unpack the carton. Take out the accessories pack from the carton. Make sure the accessories listed in the above Accessories Check List are included.
If anything missing, ask the retailer immediately to provide it to you. -
Prepare a cross head screw driver and a spanner suitable for M6 screw nut.
-
Read this instruction manual carefully before installation and use. Keep this instruction manual in a proper and safe place for future use in case needed.
CLEANING
Unplug the unit before cleaning. It should be wiped with wet cloth.
Do not use too much water.
DISPOSAL OF APPLIANCES AND BATTERIES
After the implementation of the European Directive 2002/96/EU in the national
legal system, the following applies:
Electrical and electronic devices may not be disposed of with domestic waste.
Consumers are obliged by law to return electrical and electronic devices at
the end of their service lives to the public collecting points set up for this
purpose or point of sale. Details to this are defined by the national law of
the respective country.
This symbol on the product, the instruction manual or the package indicates
that a product is subject to these regulations. By recycling, reusing the
materials or other forms of utilising old devices, you are making an
important contribution to protecting our environment.
INSTALLATION
-
The heater must be installed under a ceiling or on a wall at least 1.8 metres above from the floor. When installing the heater, please keep a distance of at least 20 cm from every direction. Please keep away from flammable materials.
-
Options 1: Wall / Ceiling, drill 2 holes on the ceiling or wall. Insert the 2 expansion bolts into the holes. Use a spanner to twist the screw nuts on the expansion bolts clockwise till they are securely located in the holes. Unscrew the screw nuts and put them aside with washers, spring washers for further use later.
Option 2: Product’s profile, drill 3 holes using drill screws in order to secure the bracket on to the profile. -
Put Steel Board onto the ceiling or wall. Let the 4 Expansion Bolts go through the 4 holes on Steel Board and fix it with the Washers, Spring Washers and Screw Nut above mentioned.
-
Mount the heater onto the wall or ceiling by sliding Upper Bracket into the open on Steel Board. Fix them together with screw M8 x 75 and M8.
-
Use a screw driver to unscrew the Screw M8 x 75 a little bit. Set the heater to a desired angle and drive Screw M8 x 75 tight. The adjustable angle is within 60 degree totally.
OPERATIONS
- Plug in the unit to a socket. Make sure the power supply is same as rated.
- Press Switch on left side of the heater to switch on/off the heater as desired.
SERVICE HOTLINE
TEL.: +49 (0) 6571 / 95117-0
FAX: +49 (0) 6571 / 95117-98
E-MAIL: INFO@50NRTH.COM
50NRTH GmbH
STRASSBURGSTR. 14-16
54516 WITTLICH / GERMANY
www.50NRTH.com
References
- palramapplications.com - This website is for sale! - palramapplications Resources and Information.
- palramapplications.com - This website is for sale! - palramapplications Resources and Information.
- palramapplications.com - This website is for sale! - palramapplications Resources and Information.
- tex.com
- Inspection Systems for the Electronics Industry – Viscom – Viscom
- 50NRTH - Exklusive Produkte für Outdoor und Garten
- Αρχική Σελίδα - Alpaco Domica
- Canopia United Kingdom - Celebrate Outdoor Living
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>