VISION 6708S Wireless Pro Controller For Nintendo Switch User Manual
- June 9, 2024
- VISION
Table of Contents
6708S Wireless Pro Controller For Nintendo Switch
Wireless Pro Controller For Nintendo Switch
User Manual
- Make sure you read this guide before using the controller.
- This controller is suitable for all the games of Switch, compatible with Android system.
- This controller adopts wireless Bluetooth connection technology.
- Built in dual motors and 6-Axis Gyro Sensor. µShare and save your captured images easily with the new dedicated screenshot button.
Operation Guide
Wireless Pro Controller For Switch
- Click ‘controllers’ on the Switch main menu interface to enter the pairing mode.
- Press and hold Y+SYNC buttons for 3 seconds to enter the pairing state, the indicated LED will fast flash. After connection, the corresponding LED will always be on.
- It has connection Wake-up function, just press the “Home” or “SYNC” button to reconnect each subsequent connection after the first successful connection.
Wireless Controller For Android Device
- Press and hold A+SYNC buttons for 3 seconds to enter the pairing
state,the LED-1 will fast flash.
And turn on the Bluetooth of your Android device to enter search mode, then click ‘Gamepad’ in the device to connect. After connection, the LED-1 will always be on.
Note! if it is difficult for the host to pair the controller, it may be that
too many Bluetooth devices are connected to the host, the Bluetooth
information needs to be cleared manually. There start from the first steps.
Product Features:
Input Voltage: DC5V/0.5A Charging interface: Type-C
Remote Range: <10m Charging time: 3h
Working Time: up to 15h Net Weight: 116g
Product Size: Approx. 6 3.1 0.8 inch (1537921mm)
Pack Contents:
1x Wireless Controller
1x User Manual
1x Charging Cable
Warning:
- The product is not water proof. Please keep it away from water, high humidity and high temperature environment.
- DO NOT attempt to modify or disassemble this product.
- DO NOT slam or hit this product hard, there may be some unnecessary damage for it
- Due to violation of above operations, warranty is invalid
FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.