PRINCESS 01.249413.01.001 Espresso and Capsule Machine Instruction Manual

: June 9, 2024
: Princess

Table of Contents

PRINCESS 01.249413.01.001 Espresso and Capsule Machine
SAFETY
Cleaning and maintenance
Steam/hot water nozzle
Boiler outlet
Descaling
PARTS DESCRIPTION
BEFORE THE FIRST USE
USE
Making espresso
Frothing milk for cappuccino
Making espresso after frothing milk
Automatically power-off function
ENVIRONMENT
Support
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PRINCESS 01.249413.01.001 Espresso and Capsule Machine

SAFETY

By ignoring the safety instructions the manufacturer cannot be held responsible for the damage.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
Never move the appliance by pulling the cord and make sure the cord cannot become entangled.
The appliance must be placed on a stable, level surface.
The user must not leave the device unattended while it is connected to the supply.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Close supervision is necessary when any appliance is used by or near children.
WARNING: Spilled food can cause serious burns. Keep appliances and cords away from children. Never drape the cord over the edge of a counter, never use an outlet below the counter, and never use with an extension cord.
The use of accessory attachments not recommended by the appliance manufacturer may cause injuries.
Do not use this appliance outdoors.
Do not place on or near a hot gas or electric burner, or in a heated oven.
Do not clean with metal scouring pads. Pieces can break off the pad and touch electrical parts, creating a risk of electric shock.
Use extreme caution when removing the frying baskets.
Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
CAUTION: To protect against damage or electric shock, do not cook in the base unit. Cook only in the frying baskets provided.
To disconnect, press the power button, then remove the plug from the wall outlet.
Do not use the frying baskets if dented or worn.
WARNING: Never deep-fry in the Aerofryer, regardless of whether the lid is on or off. THIS IS DANGEROUS, AND CAN CAUSE A FIRE AND SERIOUS DAMAGE.
Before placing baking pan or aero plate into the base, ensure both are dry by wiping with a soft cloth.
Always ensure the appliance is properly assembled before use.
Care should be taken when lifting the baking pan from the base.
To avoid possible damage from steam, place the unit away from walls and cabinets during use.
Never lift the unit by the lid side tabs.
Never touch any exposed heating elements
To protect yourself against an electric shock, do not immerse the cord, plug, or appliance in the water or any other liquid.
This appliance is intended to be used in household and similar applications such as:
- Staff kitchen areas in shops, offices, and other working environments.
- By clients in hotels, motels, and other residential-type environments.
- Bed and breakfast type environments.
- Farmhouses.
Children shall not play with the appliance.
This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local Authority or local store for recycling advice.

The universal recycling symbol, logo, or icon is an internationally recognized symbol used to designate recyclable materials. The recycling symbol is in the public domain and is not a trademark.

CE: This product complies with conformity requirements of the applicable European regulations or directives.

The Green Dot is the registered trademark of Der Grüne Punkt – Duales System Deutschland GmbH and is protected as a trademark worldwide. The logo may only be used by customers of DSD GmbH holding a valid trademark usage contract or by engaged waste management companies within the Federal Republic of Germany. This also applies to reproduction of the logo by third parties in a dictionary, an encyclopaedia or an electronic database containing a reference manual.

This symbol is used for marking materials intended to come into contact with food in the European Union as defined in regulation (EC) No 1935/2004.

EAC: The Eurasian Conformity mark (ЕАС) is a certification mark to indicate products that conform to all technical regulations of the Eurasian Customs Union.

Separate collection / Check your local municipal guidelines.

The product and packaging materials are recyclable, subject to extended manufacturer responsibility. Dispose it separately, following the illustrated packaging symbols, for better waste treatment. The Triman logo is valid in France only.

Cleaning and maintenance

Never immerse the cord, plug, or appliance itself in water or other liquids.
Always unplug the machine and make sure cool down before you clean it.
All the non-electrical parts can be washed in warm soapy water. Dry thoroughly before reusing. These parts are not dishwasher safe. Never use abrasive detergents.

Steam/hot water nozzle

Pull out the rubber tube downwards, then wash thoroughly. Check that the hole in the nozzle is not blocked, if necessary unblock them with a pin.

Boiler outlet

At lease twice a year carry out the following procedure:

Wipe away any coffee grounds from the outlet area.
Clean the boiler area with a damp cloth.
Clean the removed outlet thoroughly in hot soapy water using a brush , rinse thoroughly, make sure the holes are not blocked, and if necessary use a pin to clean.

Descaling

The appliance has to be descaled every month, otherwise the coffee taste will become bad and the scale deposited inside in the machine may cause permanent and irreparable damage to the machine.
Note: In case of using solid descaler, make sure the descaler dissolves into cold water fully before pouring into the water tank. Never use a descaler based on mineral acids such as sulphuric acid, hydrochloric acid, sulphamic acid and acetic acid(e.g. vinegar).These descalers may damage your machine.
Mix adequate descaler with cold water in a measuring jug as per its instructions. Fill the water tank up to the Max level with the prepared descaling solution. Then put the water tank back into the machine.
Make sure the filter holder is not attached and put a bowl with a capacity of at least 1500ml under the boiler outlet to collect the descaling solution.
Press down the On/Off knob and wait until the light stops blinking.
Press down the coffee function knob and allow half the solution to flow out, seriatim press the coffee function and the On/Off button to the off position to stop the flow.
Leave the machine to rest for 15 minutes, then press the On/Off knob and coffee function button until the water tank is empty, then rinse it thoroughly.
Fill the water tank with cold fresh water up to the Max level again and repeat steps 2 to 5 without rest to rinse the appliance for twice.
Note: Always rinse the machine by letting it empty at least two full water tanks.

PARTS DESCRIPTION

1. Cup warming tray	10. Cup stand
2. Tank lid	11. Drip tray
3. Water tank	12. Filter holder I
4. On/off knob	13. Filter for 2 cup dose
5. Coffee function knob	14. Filter for 1 cup dose
6. Steam function knob	15. Filter holder II
7. Indication lights	16. Filter for 1 capsule
8. Steam/hot water nozzle	17. Measuring spoon with tamper
9. Steam control knob

BEFORE THE FIRST USE

Take the appliance and accessories out the box. Remove the stickers, protective foil or plastic from the device.
Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around the device. This device is not suitable for installation in a cabinet or for outside use.
Flush the machine through with clean water in the following steps:
- Make sure all buttons are in the off position and that the steam water knob is closed by turning clockwise.
- Lift out the tank, draw up the lid and fill with cold water up to the MAX level marked. Alternatively draw up the lid and fill the tank whilst in position on the espresso machine. We recommend using filtered water as it produces better coffee and reduces limescale, never use fizzy water.
- Refit the tank, make sure that it is correctly located and apply light pressure if necessary to ensure the valve at the bottom of the tank connects with the water inlet of the machine. It is normal for water to remain in the compartment under the tank, this can be done using a sponge.
- Attach the filter holder to the machine by positioning it under the boiler outlet and turning to the right, Respectively place suitable container underneath the boiler outlet and the steam/hot water nozzle.
- Plug in the mains supply, Press down the On/Off knob then the power light will be illuminated, the coffee light will blink until it reaches the right temperature, then press the coffee function knob, the machine will be flushed, Press the coffee function knob after a while to turn off manually.
- Press down the steam function knob, the steam function light will blink, when the light stops blinking turn the steam control knob and the steam nozzle will be flushed. Press the steam function knob again to stop the machine.

Important: You can not brew espresso if you have not flushed the machine at first, the flushing cycle causes the boiler to fill with water. If you have not used the machine for water before you use it again.

USE

Preheating the espresso machine
To ensure your espresso coffee is brewed at the right temperature it is essential that the coffee appliance is preheated.

Check that the steam control knob is firmly closed (turn clockwise) and that there is water in the tank.
Put a jug under the steam nozzle.
Fit the desired filter into the filter holder (without coffee) and attach to the machine by positioning it under the boiler outlet and turning to the right, ensure is it firmly located
Position two cups under the filter holder, if you use the same cup that the coffee will be served in it will be preheated. Alternatively the cups can be preheated on the cups warming tray.
Press the On/Off knob and wait until the light stops blinking.
Press down the coffee function knob and wait until two cups of water runs into the bowl.
Press the steam function knob and wait until the light stops blinking.
Turn the steam control knob anti-clockwise and allow a little amount of water to run into the jug.

Making espresso

Preheat the appliance as above ‘Preheating the espresso machine’.
To make one or two cups of espresso: use filter holder I. Use the smaller filter for making one cup and the larger filter for two cups.
Add the coffee using the measuring spoon provided one full spoon per cup, level the surface then lightly press with the tamper of the measuring spoon, wipe off any coffee around the rim. When buying ground coffee sure it is suitable for espresso machines. Never press the coffee too firmly as the coffee will come out slowly and the cream will be of a dark color, however, if it is pressed too lightly, the coffee will come out too fast and the cream will be a light color.
To use a coffee capsule: use filter holder II. Open the bottom of the capsule filter, place a coffee capsule in it, cover and press tightly. It is also possible to use a Nespresso®* capsule.
Attach the filter holder into the boiler outlet, turn it to the right to lock into position. Put one or two cups underneath, if making one cup of coffee, center your cup in the middle. Ensure the on/off knob is pressed down then the power light will blink, wait until the light stops blinking then press down the coffee function knob to make espresso.
When you’ve enough coffee, not too much otherwise it will be too weak (optimum dosage is 30ml per cup) press the coffee function knob again. If you are not making any more coffee, press the on/off button again to turn of the appliance.
Remove the filter holder by turning to the left. There will be water on the filter when you remove it, this is normal.
To remove the used coffee from the filter holder, please lift the plastic pressing block to press the edge of filter, then tip the filter holder upside down and tap out the grounds.
Important: You can not start to make espresso until the ready light stops blinking because it means the water temperature is not high enough when the ready light is stil blinking.
Important: To avoid water leakages from the rim of the filter holder and to ensure optimum performance, it is necessary to clear any ground coffee from around the boiler outlet. Take care as the area may be hot.
Note: * Brand of a third party that is not affiliated with Princess.

Frothing milk for cappuccino

Prepare the espresso as previously described.
Make sure there is water in the tank.
Press the on/off knob for steam, the steam light will blink, wait until the light stops blinking, this indicates that the boiler has reached the correct temperature.
Partly fill a jug with milk – the milk may increase up to three times in volume so select a suitably sized jug. Cold semi skimmed milk gives the best results.
Position the jug under the steam nozzle.
Place the nozzle into the milk about 30mm deep and turn the steam control knob in an anti clockwise direction, the milk will begin to increase in volume and appear frothy. When the volume of the milk has doubled, fully immerse the nozzle and continue heating the milk. Once the desired temperature is reached(60° is optimum), stop the steam by turning the steam function knob clockwise.
Note: When operation in steam mode and with the steam function knob turned off, some water may drop from the boiler outlet or the attached filter holder. This water collects in the drip tray. Alternatively you can place a cup under the boiler outlet or the attached filter holder.
Important: Never operate the steam nozzle for longer than 2 minutes at one time.
Important: Never allow the milk to boil as this will spoil the flavour of the coffee.
Important: To prepare more than one cup of cappuccino, first make all the espresso coffees, then at the end prepare the frothed milk for all the cappuccinos

Making espresso after frothing milk

If you’re making espresso after frothing milk, you need to drain any overheated water that could burn your coffee as following.
Place a container with at least 30mm depth of cold water underneath thesteam nozzle, immerge the nozzle into the cold water at least 10mm depth. Ensuring the appliance is in the off position then turn the steam control knob anti-clockwise until there is no steam coming out the nozzle anymore. Now you will be able to make espresso again.

Automatically power-off function

The espresso machine will automatically power off when there is no operation within 25 minutes

ENVIRONMENT

This appliance should not be put into the domestic garbage at the end of its durability, but must be offered at a central point for the recycling of electric and electronic domestic appliances. This symbol on the appliance, instruction manual and packaging puts your attention to this important issue. The materials used in this appliance can be recycled. By recycling of used domestic appliances you contribute an important push to the protection of our environment. Ask your local authorities for information regarding the point of recollection.