BRILONER MAL 7402 LED Panel Instruction Manual
- June 4, 2024
- BRILONER
Table of Contents
BRILONER MAL 7402 LED Panel Instruction Manual
Mounting instructions
Safety directions / Please read this information carefully before
installing or using this product. Please keep this user manual for further reference.
-
The lamps may only be installed by authorized and qualified technicians according the valid regulations for electrical installation.
-
The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the light.
-
Maintenance of the lights is limited to the surfaces. For electrical safety reasons, this product must not be cleaned with water or other liquids. Use only a dry, lint-free cloth for cleaning.
-
y Caution! Risk of electric shock. Before connecting to the mains, always check the entire light for possible damage. Never use the light if you notice any damage.
-
! Caution! Disconnect the mains cable from the power supply before assembling or disassembling. Switch off the earth leakage circuit breaker/automatic circuit breaker or unscrew the fuse. Turn the switches to “OFF”.
-
! Caution! Before drilling the mounting holes, make sure that no gas, water or electricity pipes and wires can be drilled through or damaged in your chosen mounting location.
-
When mounting, ensure that the attachment material is suitable for the subsurface and that this surface is capable of carrying the weight of the fixture. The manufacturer is not liable for improper installation of the item on the relevant subsurface.
-
r The symbol of the crossed-out garbage can on the product or the packaging means that the product must not be disposed with ordinary household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local municipality for the point of acceptance.
-
Safety class II S. This light is specially insulated and must not be connected to an earthed conductor.
-
Safety class II. Take note that when switching on that the building site supply lines available have double or reinforced insulation up to the terminal connection area.
-
Description of the supply terminals: L = Phase N = Neutral conductor G = Earthed conductor.
-
This product is designed for direct wiring to the mains “230 V / 50 Hz”.
-
Protective covers and end covers for mains voltage control parts must always be mounted.
-
Do not install the light on a damp or conductive subsurface.
-
Please make sure that no cables get damaged during the installation work.
-
The lights have a protection class rating of “IP20“ and are solely intended for indoor use only of private households.
-
Do not look directly into the light source (illuminant, LED, etc.).
-
3 The light source of this lamp is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
-
This product contains a light source of energy efficiency class „D“, based on the EU regulation 2019/2015.
-
LED colour deviation when using different chargers may occur. The light colour and luminous strength of the LED’s can also change as a result of life span level from the lamp.
-
Y This article is not suitable for use with dimmable electric circuits.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>