TOUGH COUNTRY TB2017FRSSM Traditional Rear Bumper Instruction Manual
- June 9, 2024
- TOUGH COUNTRY
Table of Contents
TOUGH COUNTRY TB2017FRSSM Traditional Rear Bumper
Tough Country Products 1101 N. Blue Creek Rd El Campo, TX 77437
Phone : 1-877-44TOUGH
Fax: 979-543-7209
2017-2022 Ford F250-F350
Traditional Rear
- TB2017FRSSM
Tools Needed
- Ratchet
- ¾” Socket
- ¾” Wrench
- 13mm Wrench
- 21mm Socket
Bumper Removal Instructions
- Unplug 7way plug
- If equipped with rear sensors, disconnect wiring harness and remove from factory bumper after bumper has been removed from truck
- Do not pull on rear sensor from behind*
- Disconnect all wiring from factory rear bumper
- Using 21mm socket remove bumper mounting bolts
- Remove 2-13mm bolts from center of receiver and remove factory bumper
- With a 21mm socket remove L shaped brackets from frame
Installation of Tough Country Replacement Bumper:
-
Position support bracket on the outside of frame, with the l facing outward, with factory hardware and provided bolts Hand tighten bolts
-
Install bumper onto brackets with provided hardware and hand tighten only
-
Align and adjust to correct placement and tighten securely
-
If equipped with rear sensors, use small screwdriver to open retainer slightly and push sensor through retainer from the front side of the sensor
-
To remove the sensor sleeves, use the small screwdriver to depress the 4 retainers on each sleeve and gently push through
Keep position of sensors sleeves as holes are sensor sleeve specific* -
Install sleeves into factory bumper sensor holes from the front, by pushing it until it seats
-
Remove 7way plug from factory bumper and install into replacement bumper
-
Remove wiring harness from factory bumper and install onto replacement bumper
-
Install rear sensors into replacement bumper
-
Ensure all connections from wiring harness are secure
THANK YOU FOR CHOOSING TOUGH COUNTRY PRODUCTS
www.toughcountry.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>