STRONG CURRENT 30427 ANC True Wireless Earbuds User Manual
- June 5, 2024
- Strong Current
Table of Contents
ANC True Wireless Earbuds
User Manual
ANC earbuds
Model30427 ANC earbuds (White)
Button Definition
“L” “R” Earbud:
- Touch and hold for 2-3seconds: Transparency mode /Active noise cancellation
- Touch and hold for 2-3 seconds :hang up / reject phone call – Press to Play/Pause/Answer
- Double -press to skip forward
- Triple-press to skip back
Restore the factory settings
Put the earphones into the charging case and open the case cover, first press the button of the case twice, and then press the button of the case for a long time until the case shows a white LED blink, the earphones will be factory reset.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>