TRIM-TEX Fire Gasket for Drywall Installation Guide
- June 9, 2024
- TRIM-TEX
Table of Contents
TRIM-TEX Fire Gasket for Drywall
Fire Gasket® 1
Fire Gasket is the fastest firestopping solution for head-of-wall joints on the market, installing up to five times faster than traditional sealants and sprays. Fire Gasket is installed pre-drywall, and provides up to 1” of unencumbered movement.
Installation Guide
Technical Specs
Scan Below for Installation Video
Before Installation
Install Fire Gasket to the wall framing before hanging drywall. Measure, cut and dry fit the bead.
Step 1:
Remove backing on adhesive foam tape.
Step 2:
Compress the bubble gasket firmly against the adjoining structure. Pressure
the product into place while adhering it to the framing.
Step 3:
Install drywall directly over Fire Gasket per the deflection requirement
allowed by the required UL joint system reports.
Note:
- To keep the drywall gap consistent, use an appropriately sized spacer on top of drywall.
- If desired, finish top of drywall with L Bead or Tear Away L Bead.
- Fire Gasket can optionally be fastened to the framing using appropriate ½” screws through the adhesive foam on its lower leg.
- There should be no gaps left in joints between pieces. Additional sealant may be used at butt joint to ensure seamless joints.
CUSTOMER SUPPORT
3700 W Pratt Avenue, Lincolnwood, IL 60712
800-874-2333
trim-tex.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>