TRIM-TEX Rigid Low Profile Corner Bead Installation Guide
- June 9, 2024
- TRIM-TEX
Table of Contents
Rigid Low Profile Corner Bead
Installation Guide
Rigid Low Profile Corner Bead
Rigid Low Profile Corner Bead
The Rigid Low Profile Corner Bead is a variation on our standard 90-degree
vinyl corner bead that requires less mud and no setback to finish. With its
sharp rigid nose, this is a great choice for a level-five finish. Available with
an 81-degree closed angle (CA) for use with twisted or warped framing.
Installation Guide
| 
|
---|---|---
Technical Specs
| Setback: Standard|
Scan the QR Code for Installation Video
Before Installation:
Use minimal drywall setback on outside corners. Measure, cut and dry fit the
bead, leaving a ½″ gap at the floor.
Step 1:
Coat both the bead and edge of drywall with Trim-Tex 847 Spray Adhesive.
Step 2:
Press the bead in place, applying pressure to the mud legs.
Step 3:
Staple every 6”-8” using ½″ staples.
Step 4:
Finish with drywall compound.
3700 W Pratt Avenue, Lincolnwood, IL 60712
800-874-2333
trim-tex.com
Documents / Resources
|
TRIM-TEX Rigid Low Profile Corner
Bead
[pdf] Installation Guide
Rigid Low Profile Corner Bead, Rigid, Low Profile Corner Bead, Corner Bead
---|---