Hunter 19139 1 Light Flush Mount Instruction Manual
- June 4, 2024
- Hunter
Table of Contents
Hunter 19139 1 Light Flush Mount
Overview
INSTALLTION INSTRUCTION
WARNING
- To avoid possible electrical shock, before installing your light fixture, disconnect the power by turning oft the circuit breakers to the outlet bo associated with the wall switch location.
- The lighting fixture must be grounded. If the ground wire for the installation site is not present immediately STOP installation and consult a qualified electrician.
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a qualified electrician.
READ AND SAVE THESE INSTRUCTIONS
These instructions are provided for your safety. It is very important that they are read carefully and completely before beginning installation of the lighting fixture.
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the old fixture from the ceiling, including the old mounting bracket. Remove the new mounting bracket assembly from the bag. Then remove mounting screws (B) from mounting plate (A). Place the mounting plate (A) over the junction box. Pull the house wires through the center of the mounting plate (A). Secure mounting plate (A) to the junction box by tightening the screws (D).
CONNECTING THE WIRES
Have a helper support the fixture’s weight while completing the wiring. Attach the fixture’s wires to the power supply wires from the junction box. Connect black to black (Live); white to white (grounded); grounding to grounding (green or copper). Twist the ends of the wire pairs together. Then, twist on a wire connector. Make sure all twists are in the same direction. Loop fixture’s ground wire around grounding screw (C) and tighten. If there is no ground wire (green or copper) from the junction box, contact a qualified electrician.
FINISHING THE INSTALLATION
Align the holes on the top and bottom of fixture body (F) with the holes in the tabs (J) of mounting plate (A) and secure it with the supplied mounting screws (D) using the included screwdriver (E). Install light bulbs (not included) in accordance with the fixture’s specifications. Do not exceed the recommended wattage. Secure the glass (I) onto the socket (G) with screws (H). Your installation is now complete. Turn on the power and test the fixture.
CLEANING TIPS
Treat the fixture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the fixture with a clean lint-free cotton or microfiber cloth. Never spray cleaner directly onto the fixture.