GARMIN EFB-W526 Plasma Air Purifier Wall Fan User Manual

GARMIN EFB-W526 Plasma Air Purifier Wall Fan

Plasma Air Purifier Wall Fan
EFB-W526

Please read these instructions and warranty information carefully before use and keep them handy for future reference. Please register your warranty information now !For Warranty Terms & Conditions, please refer to the last page of this user manual.

Warnings & Safety Precautions

WARNING!
Read all instructions carefully before using this product.

• This product is for domestic indoor use only. If this product is used for any commercial, industrial, rental or other purposes, product warranty will be VOIDED.
• This product is not intended for use by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of this product by an adult responsible for their safety.
• Mind your children and DO NOT let children play with this product.
• Cleaning and user maintenance shall not be made by children without supervision.
• Check the voltage indicated on the rating label before using this product.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid hazards.
• Unplug this product from the power source before cleaning and maintenance.
• Contact German Pool authorized service technician for repair or maintenance of this product.

To avoid fire, electric shock and injury, you must follow the instructions listed below, and follow local electricity regulations.

1. Children, the elderly and people with disabilities or without experience must be supervised by a responsible guardian when using this product. Children should be supervised to ensure that they DO NOT play with this product as a toy.
2. Please use a separate outlet that matches the current /voltage of this product. DO NOT use with socket adaptor, power strip or share socket with other appliances.
3. Disconnect this product from the power source before any maintenance and repair. Maintenance and repair must be carried out by qualified technicians only.
4. Before moving this product, disconnect it from the power source first. When plugging or unplug-ging this product, grip by the plug, DO NOT pull on the cable.
5. If the cable is damaged, it must be replaced by the manufacturer or their authorized servicemen.
6. DO NOT pull or stretch the cable, and keep the cable away from hot surfaces.
7. DO NOT run the cable under carpets. DO NOT cover the cable with rugs or similar covers. Route the cable outside of the traffic area to avoid being tripped by the cable.
8. Turn the product off before unplugging from the power source.
9. If this product will not be used for a prolonged period of time, unplug it from the power source, and pack up the cable to avoid tripping over it.
10. To ensure proper airflow, DO NOT place items on or near the air inlet and outlet, and DO NOT let dust, lint, hair or other substance that may block airflow gather on the vents.
11. Keep this product away from heat sources and corrosive gases, and on a well ventilated and level surface. A radial distance of 150 mm should be kept all around the product to ensure adequate airflow.
12. This product is only suitable for use in a dry environment. DO NOT use this product outdoors or on a humid surface.
13. To avoid danger, DO NOT immerse this product, its cable and plug in water or other liquids. DO NOT use this product with an extension cord unless it has been tested by a qualified technician.
14. DO NOT place this product near air purifiers or similar products. DO NOT use any cleaning agents or lubricants with this product. Before cleaning and maintaining this product, unplug it from the power source.

• The power supply voltage used is must be the same as the voltage specified on the rating label of this product.
  Otherwise it may cause fire or electric shock.

• DO NOT use if the socket is loose.
  DO NOT use if the power cord, plug or socket is damaged.
  Otherwise it may cause electric shock, short circuit or fire.

• When plugging in the product, hold the plug and insert it securely into the socket.
  Otherwise it may cause electric shock, the plug heating up or fire.

• Before cleaning and maintenance, unplug the product from the power source.
  Otherwise it may cause electric shock and injury.

• DO NOT touch the power plug or control panel of the product with wet hands.
  Otherwise it may cause electric shock.

• DO NOT unplug the product by pulling on the power cord. Grip the plug firmly when unplugging the product.
  Otherwise it may cause electric shock or fire.

• DO NOT alter or disassemble the product by yourself. Disassembly or repair must be done by professional technician only.
  Otherwise it may cause fire, electric shock or injury. For maintenance, please contact German Pool Customer Service & Repair Centre.

• Remove dust on the plug regularly.
  Accumulated dust may cause the plug to become humid and lead to poor insulation. This may cause electric shock, the plug heating up and causing a fire.

Product Structure

Main Body

Control Panel

Installation Instructions

Wall-Mount Installation
WARNING!

• The product must be installed with the specific wall hook plate that comes with the product.
• Leave at least 400mm space between the hook and the ceiling.
• Leave at least 400mm space between the hook and the adjacent wall.
• The wall on which the product is to be installed must be at least 10mm thick. If the wall is not sturdy enough, the product may fall off.
• DO NOT install on plasterboard wall.
• DO NOT let the power cord be pinched between the product base and the wall.
• If the product is installed too close to the ceiling, floor or adjacent wall, it may not be able to function properly.

1. Place the wall hook plate on the spot where you want to install the product, and mark the 3 screw holes.
2. Drill the holes and insert the rubber plugs.
3. Mount the wall hook plate securely with the 3 screws.
4. Align the two holes on the back panel of the product with the hooks of the wall hook plate.
5. Slide the product downwards until it latches securely onto the wall hook plate.
6. Plug the figure-8 side of the power cable onto the product base, and plug the 3-pin plug into the socket.

Note:
If the product will not be used for a prolonged period of time, please unplug the plug for safety purposes.

Free Standing
This product can also be used as a free-standing desktop fan.

• No installation necessary.
• Make sure the desktop is level and sturdy. DO NOT place on an unsteady (eg. slanted, soft, etc.) surface to avoid the product toppling over.
• When product is being used, DO NOT place any object or fabric within 150mm of the air inlet and outlet, otherwise the air volume will be impaired, and may also cause the product to malfunction.

Operation Instructions

Air Duct Angle Setting
Before adjusting the air duct angle, make sure the product is turned off. Hold product body with one hand; with the other hand, set the air duct forward or backward.

Operating Via Control Panel
Switch On/Off & Adjusting Wind Speed

1. Touch the Control Panel to turn on the product. Buzzer beeps once, product starts to operate.
2. When product is in operation, touch Control Panel to adjust wind speed, display panel shows current wind speed (01-09). Each touch will increase the wind speed by one level; at wind speed 09, touching again will return wind speed to 01.
3. When a product is in operation, touch and hold Control Panel for 2 seconds, buzzer beeps twice, and product turns off.

Oscillation
When product is in operation, touch and hold Control Panel for 1 second to activate or stop oscillation.
Operating Via Remote Control

Note:
The Remote Control should be pointed directly at the Remote Control Signal Receiver on the Display Panel to maximize remote control reception.

Note:
The following phenomena may occur during operation:

• This product may respond to the remote control of other devices.
• If you use the remote control of this product, other devices may respond. This is due to overlap-ping frequencies of the Remote Control. There is no quality problem in the product itself. To avoid interference, keep the Remote Control away from other electrical devices during operation.

Installing The Battery
WARNING!

• The Remote Control contains a button cell battery. If the button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep batteries out of children’s reach at all times.
• If accidentally swallow battery, seek medical attention immediately!

1. There is a buckle located at the bottom of the remote control. Press the buckle inward and pull out the battery slot.
2. Place the battery onto the battery slot. Make sure the battery’s polarity is correct.
3. Reinsert the battery slot into the Remote Control until the buckle snaps shut.

Note:

• If the Remote Control will not be used for a prolonged period of time, please remove the battery.
• DO NOT recharge the battery.

Cleaning & Maintenance

WARNING!

• Disconnect the product from the power source before cleaning and maintenance.
• DO NOT touch the product or the plug with wet hands to avoid electric shock.

1. When cleaning the product, DO NOT wet or splash water on the product to avoid water entering inside and causing electric shock, short circuit or malfunction.
2. Use a dry soft cloth to lightly wipe the surface of the product; or use a soft cloth moistened with diluted mild detergent to clean, then wipe dry with a dry soft cloth.
3. DO NOT let dust build up on or around the air inlet and outlet, as too much dust will reduce the efficiency of the product or may even cause malfunction. Regularly use a soft brush or vacuum cleaner to remove any dust accumulated on the air inlet and outlet.
4. DO NOT use banana oil, naphtha, alcohol, kerosene, benzine, abrasive powders, alkaline cleansers, harsh brush etc. to clean this product, as it may damage the surface or cause discoloration.
5. After using this product for a long time, dust may accumulate on or around the plug and socket area, causing the plug to become humid and lead to poor insulation. This may lead to electric shock, the plug heating up and fire hazard. Therefore, please regularly unplug the plug and wipe with a dry cloth.

Troubleshooting

the socket?
Remote Control does not function| Is the battery dead?

Is the battery inserted correctly?

Is the Remote Control aligned with the Signal Receiver?

WARNING!
If error remains, please contact German Pool Customer Service & Repair Centre. DO NOT disassemble product unless by a qualified technician.

Technical Specification

• All information in this manual is for reference only. Specification is subject to change without prior notice.
• If there is any inconsistency or ambiguity between the English version and the Chinese version of this manual, the Chinese version shall prevail.
• Refer to www.germanpool.com for the most updated version of the User Manual.

Warranty Terms & Conditions

Under normal operations, the product will gurantee a 1-year full warranty provided by German Pool (effective from the date of purchase).

• This warranty is not valid until customer registration information is received by our Service Centre within 10 days of purchase via one of the following means:

  1. Visit our website and register online: www.germanpool.com/warranty
  2. Complete all the fields on the attached Warranty Card and mail it back to our Customer Service Centre.

Please fill out the form below. This information and the original purchase invoice will be required for any repairs. Warranty will be invalidated if information provided is found to be inaccurate.

Serial No. :
Purchased From :
Invoice No. :
Purchase Date :

1. Customer who fails to present original purchase invoice will not be eligible for free warranty service.
2. Customer should always follow the operating instructions. This warranty does not apply to:
   • labour costs for on-site installation, check-up, repair, replacement of parts and other transportation costs;
   • damages caused by accidents of any kind (including material transfer and others);
   • operating failures resulting from applying incorrect voltage, improper usage, and unauthorized installations or repairs.
3. This warranty is invalid if:
   • the purchase invoice is modified by an unauthorized party;
   • the product is used for any commercial or industrial purposes;
   • the product is repaired or modified by unauthorized personnel, or unauthorized parts are installed;
   • the serial number is modified, damaged or removed from the product.
4. German Pool will, at its discretion, repair or replace any defective part.
5. This warranty will be void if there is any transfer of ownership from the original purchaser.

Customer Service & Repair Centre

Hong Kong
Unit B, G/F, Sunshine Kowloon Bay
Cargo Centre, 59 Tai Yip Street, Kowloon
Kowloon, Hong Kong
Tel : +852 2333 6249
Fax : +852 2356 9798
Email :repairs@germanpool.com
This warranty is valid only in Hong Kong and Macau
German Pool (Hong Kong) Limited
www.germanpool.com
Hong Kong
Room 113. Newport Centre Phase II. 116 Ma Tau
Kok Road. Tokwawan. Kowloon. Hong Kong.
Tel: +852 2773 2888
Fax:+852 2765 8215© All rights reserved. Copying, reproducing or using the contents of this manual is not allowed without prior authorization from German Pool, violators will be prosecuted.

References

• 德國寶German Pool | 家庭電器、廚櫃、傢俬 | 香港十大名牌

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>