V-TAC VT-809 LED Panel Lights Instruction Manual
- June 5, 2024
- V TAC
Table of Contents
V-TAC VT-809 LED Panel Lights Instruction Manual
TECHNICAL DATA:
| Model No: | VT-809 | VT-1509 | VT-2209 |
|---|---|---|---|
| Watts: | 8W | 15W | 22W |
| Lumens: | 800lm | 1500lm | 2200lm |
| Beam Angle: | 120° | 120° | 120° |
| PF: | >0.9 | >0.9 | >0.9 |
| CRI: | >80 | >80 | >80 |
| Protection Rating: | IP20 | IP20 | IP20 |
| Direct Connect Voltage: | 12V-24V | 24V-48V | 36V-72V |
| Input Voltage: | AC:85~265V,50/60Hz | AC:85~265V,50/60Hz |
AC:85~265V,50/60Hz
Operating Temperature:| -20°C to +45°C| -20°C to +45°C| -20°C to +45°C
Unit Size:| SQ: 142x142x40mm| SQ: 192x192x40mm| SQ: 240x240x40mm
RD: 142mmx40mm| RD: 192mmx40mm| RD: 240mmx40mm
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the
best. Please read these instructions carefully before starting the installing
and keep this manual handy for future reference.
If you have any another query, please contact our dealer or local vendor from
whom you have purchased the product. They are trained and ready to serve you
at the best. The warranty is valid for 2 years from the date of purchase. The
warranty does not apply to damage caused by incorrect installation or abnormal
wear and tear. The company gives no warranty against damage to any surface due
to incorrect removal and installation of the product. The products are
suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day
would void the warranty.
This product is warranted for manufacturing defects only.
WARNING
- Please make sure to turn off the power before starting the installation.
- The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole luminaire should be replaced.
NOTICE
- Lighting installation should not be covered. Leave some spaced around the fixture for ventilation.
- Risk of shock, hence disconnect at fuse or circuit breaker before installation or servicing.
- Risk of fire, supply conductors (power wires) conneting fixture must be rated minimmum 90°C. If uncertain, consult electrician
INSTALLATION REQUIREMENT:
- Install only by certified electrician
- Please connect with the driver properly before connecting main supply.
- The lighting should be located in dry area.
INSTALLATION DIAGRAM:
Step 1: Fix the hanging board with Screws
Step 2: Wiring the AC source cable to the driver, and wiring the DC cable of
the panel to the driver
Step 3. Fix the Panel on the hanging board
Step 4: Turn ON the switch and test the Panel
This marking indicates that this product should not be disposed of with other household wastes.
Caution, risk of electric shock.