Shenzhen ZFX Technology PI5D Gaming Headset with USB Transmitter User Guide

Shenzhen ZFX Technology PI5D Gaming Headset with USB Transmitter

PRODUCT OVERVIEW

1. Adaptive design headband
2. Mirco USB cable for charging
3. Pluggable Microphone
4. Soft Ear cushion
5. USB Transmitter
6. Connect LED indicator (Transmitter)
7. Microphone on/off
8. Volume control
9. Microphone Jack
10. 3.5mm jack for wired
11. Micro-USB for charging
12. Power & Backlight on/breathing/off mode
13. Connect & charging LED indicator(Headset)

POWER ON/OFF

• To power on the headset press and hold the power button for at least 3 seconds. The LED indicator will Bule.
• To power off the headset press and hold the power button for at least 3 seconds. The LED indicator will off.

Note: If no sound source input is detected within 5 minutes, the headset will automatically shut down. Press the power button to turn on headset again.

CHARGING

1. You can charge the headset to use the micro-USB cable to the charging port on the headset, and plug the other end into any USB power source(5V/1A)
2. LED indicator will Red when charging, will off when charging full.

• The headset will turn off automatically when the power exhausted

SETUP

1. Plug the USB transmitter to the USB port of PC/Laptop/PS.
2. Power up the Headphone and will connect the USB transmitter automatically in 5-8 seconds, the LED indicator on Headphone will turn to solid Blue
3. USB transmitter can be automatically connected to the headset by inserting it into the PC. if there is no sound from the headset, you need to change the audio output device and the recording device to an external USB device in the audio settings of the PC/Laptop/PS.

WARNING

FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject tothe following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operatetheequipment. This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to part 15 of the FCC Rules. These limitsaredesigned to provide reasonable protection against harmful interferenceinaresidential installation. This equipment generates uses and can radiateradio frequency energy and, if not installed and used in accordance withtheinstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interferencetoradio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different fromthat towhich the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>