Hunter 19630 Bearden 8 Light Linear Chandelier Owner’s Manual
- June 9, 2024
- Hunter
Table of Contents
Hunter 19630 Bearden 8 Light Linear Chandelier Owner’s Manual
PREPARING FOR INSTALLATION
Carefully remove all contents from the carton. Shut off the power at the circuit breaker and completely remove the the bag. Put the drywall anchors (C) inside the holes in the ceiling. Place the mounting plate (D) over the junction box so that mounting screws (B) extend out away from the ceiling. Pull the house wires through the center of mounting plate (D). Secure mounting plate (D) to the junction box by tightening the screws (F) then insert the drywall screws (E) through the mounting plate (D) into the drywall anchors (C).
ASSEMBLING THE FIXTURE
wires to desired length .Leave at least 8 to 10 inches of wire in addition to
the desired length and slide any excess rods Thread the wires through the rods
and pull the wires until taut before connecting the rods together. All threads
should be engaged but do not overtighten (some manual straightening of the
down rods may be required). Screw the lower the threaded post (N) of the top
rod. Put the center of threaded post (N) through the wire rope loop (K) and
washers (I). Secure the reinforcing plate and canopy with the hex nut (H) on
threaded post (N). Secure the screw collar loop (A) into mounting plate (D).
Hide wire rope inside the canopy (L).
CONNECTING THE WIRES
box. Connect black to black (live); white to white (neutral);
grounding to grounding (green or copper).Twist the ends of the wire pairs
together. Then, twist on a wire connector. Make sure all twists are screw
(G) and tighten. If there is no ground wire (g)
FINISHING THE INSTALLATION
se canopy (L) to mounting plate (D) and position mounting screws (B) so that they protrude through the open
WARNING
- To avoid possible electri calshock, before by turning off the circuit breakers to the outlet box associated with the wall switch location
- ground wire for the installation site is not present, immediately STOP installation and consult a
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring or in doubt, consult a
Tools
-
Ladder
-
Screwdriver
-
Pliers
-
Wire Strippers
-
Drill
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>