oraimo Rock OEB-01DN True Wireless Earbuds User Guide

June 9, 2024
oraimo

True Wireless Earbuds

WELCOME GUIDE

  • For safety issue, the product remains low capacity during shipping. Please fully charge the product before initial use!
    Please read this Guide carefully before using the product

PACKAGE CONTENTS

PRODUCT OVERVIEW

BASIC PRODUCT SPECIFICATIONS
Earbuds
Range: Up to 15m
Music play time: Up to 8 hours on single charge, case provides additional 16 hours
Battery capacity: 60mAh(each earbud) Charging time: Approx. 1.5 hours Charging Case
Battery capacity: 400mAh
Charging time:
Approx.l hour and 40 mins.
*oraimo Lab test results
If the charging case is fully charged, it can recharge the earbuds about 2 times.

USING YOUR EARBUDS

Please fully charge the product before initial use.

Earbuds will turn on and enter pairing mode automatically when taken out of the charging case for the first time use.

Earbud Status Indicator Status
Fast flashing blue on both earbuds Power on
Fast flashing blue on one earbud ‘
slow flashing blue on the other one. Bluetooth Pairing
Lights off Connected to a device

Make sure the distance of the earbuds and your device is less than 1 metre / 3.3 feet at the first time of connection.
When turned on, the earbuds will automatically connect to the last connected device if available. If not, the earbuds will enter pairing mode.
Under any abnormal condition, return the earbuds to the charging case with the lid closed for 10 seconds and then take out again.
Turn Off
The earbuds will automatically turn off after 3 minutes if no device is connected.
When the earbuds are in the charging case, it will automatically turn off after being fully charged.

CHARGING YOUR EARBUDS

Earbuds will be charged automatically once they are returned to the charging case.

oraimo Rock OEB 01DN True Wireless Earbuds-fig4

CHARGING YOUR CASE
Use the included Type-C charging cable to charge the case.

Case Status Indicator Status
Slow flashing red Charging
Steady red (*Lights off when you pull out the charging cable Fully Charged

CASE POWER LEVEL
Please fully charge the product before initial use.

Case Status Indicator Power Level
Steady blue for four seconds and off Normal
Slow flashing blue for four times and off Low

slow flashing
  Lights on
Lights off
Put the earbuds into the charging case to check case power level

CONTROLS


| Tap one earbud twice| Play/Pause
| Tap and hold on the left earbud for two seconds| Previous track
| Tap and hold on the right earbud for 2 seconds| Next track

| Tap one earbud twice| Answer/End call
| Tap and hold on one earbud for two seconds| Reject call
Others

| Tap one earbud for three times| Activate Voice Assistant
| Tap one earbud for four times *Please make sure both earbuds are Bluetooth disconnected.| Clear pairing list of the
earbuds

ATTENTION

  • Use original or certified cables
  • Do not expose to liquids
  • Do not disassemble
  • Avoid dropping
  • Avoid extreme temperatures
  • Do not use the product outdoors during a thunderstorm
  • Do not use any corrosive cleaner/oil to clean

CONSIDERATE HINTS

  1. Do not turn up the volume to a fair high level constantly as this could shorten the service life of this product or impair your hearing.
  2. When encounter any fault during operation, please cut off the power supply and disconnect the Type-C cable to prevent further damage to the product or other components.
  3. The wireless transmission range or connectivity could be affected by low battery power. In that case, please recharge immediately.

365 DAYS WARRANTY
CUSTOMER SERVICE
Email
India: care.in@oraimo.com
Nigeria: care.ng@oraimo.com
Kenya: care.ke@oraimo.com
Ghana: care.gh@oraimo.com
Morocco: care.ma@oraimo.com
Egypt: care.eg@oraimo.com
South Africa: care.za@oraimo.com
Others: service@carlcare.com

True Wireless Earbuds
Model OEB-E01DN Hereby, ORAIMO TECHNOLOGY UNITED. Declares that this True Wireless Earbuds is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU. FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE : Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/T/ technician for help.

FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
CAUTION
1.Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to the instructions.
– disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
– leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
-a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
2.The product shall only be connected to a US8 interface of version U5E12.0 3.EUT Temperature: :0 C – +45 C
Operating Frequency:
BT: 2402-2480MHz Modulation mode: GESK, t /4-DOPSK, 8DPSK
RF output power :
BT left earphone: 8.05dBm
BT right earphone:8.61dBm

WARRANTY CERTIFICATE

Name :|
---|---
Address :|
Tel. No. :|
Date of purchase : (ddimm/yy)|
Store name :|
Warranty period :|

WARRANTY TERMS & CONDITIONS

  • All quality-related defects on items sold directly by oraimo or oraimo’s authorized resellers are covered by an extensive warranty, starting from the date of purchase.
  • oraimo’s limited warranty is restricted to the country of purchase. The limited warranty is void on items taken outside the country they were originally bought in or shipped to directly from an authorized online purchase.
  • This warranty covers only original oraimo products. It is not applicable to normal wear and tear, or any defects arising from damage caused by misuse of this product.
  • Warranty is for the primary product only nor transferable. Any free additional product(s) are not covered in this warranty.
  • If the product fails regardless of usage in compliance with the instruction manual and other written precaution, replacement will be provided free of charge.
  • To claim the warranty, contact the services team from the platform or store where you bought from.

For more information, please visit:

|
---|---
http://www.oraimo.com| https://www.facebook.com/oraimoAccessories

@oraimo accessories

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals