oraimo OBS-75D Boom Bass Go Boom Wireless Speaker User Guide
- June 9, 2024
- oraimo
Table of Contents
oraimo OBS-75D Boom Bass Go Boom Wireless Speaker
WELCOME GUIDE
For safety issue, the speaker battery remains low capacity during shipping.
Please fully charge the battery before use!
Please read this guide carefully before using the product
Package Contents
Product Overview
- Built-in Microphone
- Volume Down/Previous Track Button
- Volume Up/Next Track Button
- Light Effect Switch Button
- Play/Pause
- Mode Switch Button
- TWS Pairing Button
- Power Button
- Power Level Indicator
- 6.5mm Line-in Microphone Input
- USB Flash Drive Port
- 3.5mm AUX Input
- Type-C Charging Port
Basic Product Specifications
oraimo Lab test results
Using Your Speaker
Power on / off
| LED Ring Indicator | Status |
|---|---|
| Slow Flashing Blue | ON |
| Lights off | OFF |
Slow flashing
Lights off
The speaker will automatically turn off after 10 minutes if no device is
connected.
When in USB or AUX in mode, the speaker will automatically turn off after 10
minutes if it is paused.
Pair with your device
Slow flashing
Steady Blue
When turned on, the speaker will automatically connect to the last connected
device if available.
Otherwise the speaker will enter pairing mode.
Having a connection problem? Remove “oraimo Boom” from your device’s BT list
and ensure the speaker is within 1 meter from the device. Start pairing
process again. For the best sound quality, make sure there is a clear line of
sight between the connected device and the speaker.
Charge the speaker
| LED Indicator | Status |
|---|---|
| Flashing White in Sequence | Charging |
| Steady white | Fully charged |
- Flashing White
- Steady white
Use the included Type-C cable to charge the speaker and charge the speaker
fully before first use.
Disconnect your speaker from the charger when fully charged.
Do not charge your speaker for extended periods.
Battery Power Level
- Flashing White
- Steady white
- Lights off
You can check the current power level through the LED indicators when the
speaker not in charging.
It has voice prompt when the battery is low.
Connected via FM
Short press Mode Switch Button to enter FM mode under the Bluetooth mode without AUX and USB connection. When the connection is successful, a voice prompt will be heard.
Connected via USB Drive
Upon detecting that a device is connected via USB Drive port, the speaker will
enter USB Drive mode.
When the connection is successful, a voice prompt will be heard.
Connected via AUX
Upon detecting that a device is connected via AUX port, the speaker will enter
AUX Mode.
When the connection is successful, a voice prompt will be heard.
TWS Pairing- Connected to the other oraimo Boom
Please put two Boom within 1 metre. Short press TWS Pairing Button on one speaker to enter TWS Pairing mode, and it will search the other Boom automatically. When the connection is successful, a voice prompt will be heard. The speaker can only successfully connect with the other oraimo Boom under the Bluetooth mode.
- Flashing White
- Steady white
- Flashing blue
- Steady blue
Controls
| Short press once| Play / Pause
| Short press once| Volume down
Long press for 1 second| Previous track
| Short press once| Volume up
Long press for 1 second| Next track
| Short press once| Answer/End a call
Long press for 1 second| Reject call
Long press for 1 second| Activate Voice Assistant
| Short press once| Mute/Unmute
Long press for 1 second| Start/Stop to search station
| Short press once| Volume down
Long press for 1 second| Previous station
| Short press once| Volume up
Long press for 1 second| Next station
| Short press once| Play / Pause
| Short press once| Volume down
Long press for 1 second| Previous track
| Short press once| Volume up
Long press for 1 second| Next track
Attention
- To preserve battery lifespan, fully charge at least once every 45 days
- Use original or certified cables
- Do not expose to liquids
- Do not disassemble
- Avoid dropping
- Avoid extreme temperatures
Trouble Shooting
| Symptom | Solution |
|---|
Battery does not charge
|
Make sure you are using the oraimo’s original USB cable. Connect the USB cable to a different USB power supply. Connect to a different DC (mains) power source.
Speaker does not pair with mobile device| On your mobile device, turn the BT feature off and then on. Remove your speaker from the BT history on your device. Pair your device again.
No sound
| On your mobile device, turn the BT feature off and then on. Remove your speaker from the BT history on your device. Pair your device again.
Increase the volume on your soundbar, your device and music source.
No sound from a cabled device
| Power on the device and play music.
Increase the volume on your speaker and device. Connect a different device.
Poor sound quality| Use a different music source.
Pair with a different device. Increase the volume on the device. Check device
audio settings.
Poor sound quality from a cabled device| Increase the volume on your speaker
and device. Connect a different device. Check device audio settings.
Considerate Hints
Do not turn up the volume to a fair high level constantly as this could
shorten the service life of this product or impair your hearing.
When encounter any fault during operation, please cut off the power supply and
disconnect the USB cable to prevent further damage to the product or other
components.
The wireless transmission range or connectivity could be affected by low
battery power. In that case,please recharge immediately.
Customer Service
365 DAYS WARRANTY
Email: [email protected]
FCC Caution
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.
Wireless Speaker
Model: OBS-75D
Hereby, ORAIMO TECHNOLOGY LIMITED.
Declares that this Wireless Speaker is in compliance with the essential
requirements and other relevant provisions of directive 2014/53/EU.
CAUTION：
- Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to the instructions.
- disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
- a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
- The product shall only be connected to a USB interface of version USB2.0
- EUT Temperature: :0℃～+45℃
Operating Frequency:
BT: 2402-2480MHz
Modulation mode:
GFSK, /4-DQPSK, 8DPSK
RF output power (only for CE):
BT: 0.64dBm
EU Declaration of Conformity
In accordance with EU Directives and Regulations
Company name: ORAIMO TECHNOLOGY LIMITED
Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET
FOTAN NT HONGKONG as the manufacturerhereby declares under our sole
responsibility that the,Product(s): Wireless Speaker
Model name: OBS-75D is in conformity with the essential requirements of the RE
Directive 2014/53/EU:
Radio Article 3.2 ETSI EN 300 328 V2.2.2 (2019-07)
EMC ETSI EN 301 489-1 V2.2.3 (2019-11)
Article 3.1(b) ETSI EN 301 489-17 V3.2.4 (2020-09);
Safety EN IEC 62368-1:2020+A11:2020
Article 3.1(a)
Health EN 50663:2017, EN 62479:2010
Article 3.1(a)
An EU Type Examination Certificate for this Product was issued in accordance with Annex III (Module B) of the 2014/53/EU Radio Equipment Directive by Bay Area Compliance Laboratories Corp. (2014/53/EU Radio Equipment Directive Notified Body Identification Number 1313)
Signed on behalf of ORAIMO TECHNOLOGY LIMITED
(Signature of authorized person)
Nengyong.Wu
Manager
Date: 2022-06-24
Warranty Certificate
- All quality-related defects on items sold directly by oraimo or oraimo’s authorized resellers are covered by an extensive warranty, starting from the date of purchase. oraimo’s limited warranty is restricted to the country of purchase. The limited warranty is void on items taken outside the country they were originally bought in or shipped to directly from an authorized online purchase.
- This warranty covers only original oraimo products. It is not applicable to normal wear and tear, or any defects arising from damage caused by misuse of this product.
- Warranty is for the primary product only nor transferable. Any free additional product(s) are not covered in this warranty.
- If the product fails regardless of usage in compliance with the instruction manual and other written precaution, replacement will be provided free of charge.
- To receive replacement, bring the warranty certificate and the product itself to the store from where you have purchased the product.
For more information, please visit:
www.oraimo.com
@oraimo accessories