dals FGM6-CC-WH 6 Inch 15 Watt Pivot LED Gimbal Downlight User Manual

dals FGM6-CC-WH 6 Inch 15 Watt Pivot LED Gimbal Downlight User Manual

Installation guide for

FGM3-CC-XX
FGM4-CC-XX
FGM6-CC-XX

ITEMS INCLUDED IN THE BOX

1. 1x LED gimbal light with CCT switch
2. 1x Junction box with integrated driver

SIDE VIEW OF INSTALLATION / VUE DE COTE DE L’INSTALLATIOND’ECLAIRAGE

WARRANTY

DALS offers a warranty of 5 years from the date of purchase that covers repair or replacement of defective parts of the housing, optics, and electronics.
To contact DALS customer service call to 1-877-430-1818 or send an e-mail to [email protected]

[](https://manuals.plus/wp-content/uploads/2023/03/dals-FGM6-CC-

WH-6-Inch-15-Watt-Pivot-LED-Gimbal-Downlight-User-Manual_4.png)BEFORE YOU START

BEFORE STARTING INSTALLATION, SHUT THE LINE FEED POWER OFF USING THE CIRCUIT BREAKER.
Instructions pertaining to a risk of fire, electric shock or injury to persons. Recessed downlight installation requires knowledge of luminaires electrical systems. Installation should be done by a certified electrician. To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. Suitable for wet Locations, Energy Star rated, IC-rated for direct contact with insulation and ETL certified listed compliant.
This class B digital apparatus complies with Canadian ICES-005. This digital apparatus does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

INSTALLATION INSTRUCTIONS

1. Drill hole in ceiling and prepare supply wires. Install and unshield the line feed wire 6» (15 cm) and strip wires 5/8» (1.6 cm). Bring supply power to junction box through knockout
   

2. Open the lid of the junction box. Use the wirenuts to match the white wire from the line feed with the white wire of the junction box, to match the black wire from the line feed with the black wire of the junction box and to match the copper wire from the line feed and with the green wire of the junction box.
   

3. Route junction box through cut-out and connect recessed LED pannel to junction box with the quick connector.
   

4. Compress the springs and push the fixture in the opening. It is easier to do one spring at a time.
   

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>