Sonoff MINIR4 462x58mm Mini Extreme User Guide
- June 9, 2024
- SonOFF
Table of Contents
MINIR4 462x58mm Mini Extreme
Power Off
Please install and maintain the device by a professional electrician. To avoid electric shock hazard, do not operate any connection or contact the terminal connector while the device is powered on.
Wiring Instruction
- No maer S1 and S2 are connected or left idle to the external switch, this advice can be controlled by a automation or the App.
- To avoid d imaging the equipment and c using danger, it is forbidden toconnectS1 to strong electricity such as neutral wire or earth wire or to connect S2 to strong electricity such as live wire, neutral wire, earth wire and etc.
- Make sure all wires are connected correctly.
Download de We Link App
POWER ON
After powering on, the device will enter the Bluetooth Pairing Mode during the
first use. The LED Indicator changes In a cycle
The device will exit the Bluetooth Pairing Mode if not paired within 1 mints
if you want to enter this mode, please long press but ton for about So until
the LED indicator changes in a cycle of two short and one long flash and
release.
Add device
Tap”+” and select “Bluetooth Pairing•, then operate following the prompt on the App.
Add We Link-Remote Sub-devices
Enter the Device Settings page on the We Link App, select “We Link-Remote sub- devices” and tap “Add”, then trigger the sub-device to add it successfully.
User Manual
https://sonoff.tech/usermanuaIs
scan the QR code or visit the website to learn about the detailed user manual and help. Scanned Sie den QR-Code order besuchen Sie die Website.
FCC Warning
Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must a accept any Interference a received,
Including Interference
The it may cause undesired operation. FCC Radic1tion Exposure Stc1tement: This
equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operc1ted
with minimum distance 20cm between the radiator your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential Installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used In
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna
-
Increase the separation between the equipment and receiver.
connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -
Consult the dealer or an experienced radian technician for help.
IC Warning
This device complies with Innovation, Science and Economic Development Canada
license exempt RSS standard (SJ. operation is subject to the following two
conditions:
- This device may no cause in Reference, and
- This device must accept any interference ,including Interference that may cause undesired operation of the device.
https://sonoff.tech/usermanuals
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>