FEIT Electric 950CA 50-Watt Equivalent Daylight Instruction Manual
- June 9, 2024
- Feit Electric
Table of Contents
FEIT Electric 950CA 50-Watt Equivalent Daylight
INSTALLATION & OPERATING INSTRUCTIONS
READ & SAVE IMPORTANT SAFETY INSTRUCTIONS
Please read and understand this entire manual before attempting to assemble,
operate or install this product.
- This product must be installed in accordance with any applicable installation code(s) by a qualified electrician or person familiar with the construction and operation of the product and the hazards involved.
- RISK OF FIRE OR ELECTRIC SHOCK : The electrical rating of this product is 120V AC.
- WARNING – RISK OF FIRE OR ELECTRIC SHOCK: Install this product only in luminaires that have the construction features and dimensions shown in this manual.
- WARNING – To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.
- THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS
- DANGER- RISK OF SHOCK-DISCONNECT POWER BEFORE INSTALLATION
- WET LOCATION LISTED, ACCEPTABLE IN SHOWER INSTALLATIONS.
- Suitable for Type IC Housings
- Suitable for Type Non-IC Housings
- Suitable for Air Tight Housings.
CAUTION: to avoid possible electrical shock, be sure that power supply is turned off at fuse box or circuit breaker before installing or servicing fixture. For your safety, read and understand instructions completely before beginning installation.
PACKAGE CONTENTS
Before beginning installation of this product, make sure all parts are present. Compare parts with package contents list and diagram as below. If any part is missing or damaged, do not attempt to assemble, install or operate this product.
COMPONENTS INCLUDED
- A MEDIUM BASE ADAPTER
- B RECESSED DOWNLIGHT ASSEMBLY
- C INSTRUCTION MANUAL
General wiring configuration
Installation into Existing Recessed Incandescent Fixture:
For use with 4″ recessed housings (housing sold separately) LED recessed trim will fit into select existing 4″ nominal incandescent housings.
- Step 1. Turn OFF power at switch and fusebox or circuit breaker.
- Step 2. Remove existing trim installed in recessed housing (if necessary).
- Step 3. Install adapter into socket (see FIG. 2).
- Step 4. Connect the two terminals together (see FIG. 3).
- Step 5. Gently push trim into place (see FIG. 4).
WARNING – Risk of fire or electric shock. LED Recessed Downlight
installation requires knowledge of luminaires electrical systems. If not
qualified, do not attempt installation. Contact a qualified electrician.
WARNING – Risk of fire or electric shock. Install this product only in
the luminaires that have the construction features and dimensions shown in the
photographs and/or drawings.
Do not make or alter any open holes in an enclosure of wiring or electrical
components during installation.
WARNING – To prevent wiring damage or abrasion, do not expose wiring to
edges of sheet metal or other sharp objects.
WARNING – RISK OF FIRE OR ELECTRIC SHOCK. DO NOT ALTER, RELOCATE, OR
REMOVE WIRING, LAMPHOLDERS, POWER SUPPLY, OR ANY OTHER ELECTRICAL COMPONENT.
MIN. LAMP COMPARTMENT DIMENSIONS: 102mm (4 in) DIA X 140mm (5.5 in) HEIGHT
PRODUCT ELECTRIC RATING
THE RECESSED DOWNLIGHT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY UL OR AUTHORITIES HAVING
JURISDICTION.
Replace with LEDR4B/950CA/MP/6 type LED light.
To order contact FEIT ELECTRIC COMPANY
Tel: 562-463-2852
Http: www.feit.com
Email: info@feit.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>